Panasonic sa-ht833v User Manual

Page of 52
5
RQT7921
Simple setup
Preparation
≥To prevent damage or scratches, lay down a soft cloth and perform assembly on it.
≥For assembly, use a Phillips-head screwdriver.
≥Make sure you have all the indicated components before starting assembly, setup, and connection.
≥There is no difference between the right and left speakers and pipes.
1
Attach pipes B to the bases.
A
Insert pipe B.
B
Secure pipe B to the base.
Ensure the screws are securely fastened.
2
Assemble the pipes.
A
Thread the speaker cable from Pipe A through Pipe B 
and the base.
For quicker threading, loosely fold the cable in half (do not 
crease), pass the folded portion through the pipe, and then 
pull the rest of the cable through the base.
B
Join Pipe A to Pipe B.
C
Secure the pipes.
Ensure the screw is securely fastened.
3
Attach pipes A to the speakers.
Slot the screw head in between the 2 stoppers of the speaker 
groove.
Align the screw head with the speaker groove.
Ensure the pipe is fastened on straight by gradually tightening the right 
and left screws alternately until fully tightened.
To prevent short-circuit, do not cover the connection terminals 
with the pipe.
4
Connect the speaker cables.
5
Secure the speaker cable to the base.
[Note]
You can use the front speakers without assembling with the stands. In this case, attach the included 
rubber pads to the base of the speakers. This prevents vibration from causing the speakers to move or 
fall over. Use 4 pads per speaker.
STEP
1
Front speaker assembly
The supplied stands are specially designed for 
attachment to Panasonic SB-FS730 front speakers. 
Use only as indicated in this setup.
2
kFront 
speakers
2
kBases
2
kPipe A 
(with a cable)
2
kPipe B
4
kPipes
4
kWasher 
screws
2
kSmall 
screws
4
kBracket 
screws
2
kBrackets
8
kRubber 
pads 
Match these holes when 
you insert the pipe.
Base
Pipe B
Phillips-head 
screwdriver
Washer screws
Cable
Pipe B
Cable
Pipe A
Pipe B
Small screw
Pipe B
Pipe A
Bracket screws
Front speaker 
Connection terminals
Bracket
Pipe A
Stoppers
Screw head
Rear of the speaker
Twist the vinyl tip and pull off.
If the cords do not have vinyl tips, 
directly connect them to the terminals.
_:
 White
`:
 
Blue
Push!
Bottom side of base
A
Press the speaker 
cable into the 
base cover groove 
as far as possible.
Cable
B
Press the speaker 
cable against the 
base while 
threading it 
between the pegs.
RQT7921-P_ENG.book  5 ページ  2005年5月25日 水曜日 午後3時24分