Panasonic sc-ak78 User Manual

Page of 44
RQT5289
14
Presetting radio broadcasts
• Up to 12 stations can be set in each band with automatic or manual
memory presetting.
• If broadcast frequencies are preset in the memory, you can easily
tune in any of these frequencies from the system or remote control
unit.
• You can preset just those stations you like. (See “Presetting only
your favorite stations” below.)
1. Press [TUNER/BAND] to select band.
The power will come on automatically.
Every time you press the button; “FM” 
 “AM”.
2. Press [   , TUNE MODE] to select “MANUAL”.
Every time you press the button; “MANUAL” 
 “PRESET”.
3. Press [TUNE / TIME ADJ(   or   )] until the dis-
play shows the frequency from which you want
to begin automatic memory presetting.
Tips on tuning in radio stations
 Hold down either [TUNE/TIME ADJ ( 
 or 
 )] until the fre-
quency numbers start scrolling.
 When near to the frequency you are looking for, press [TUNE/
TIME ADJ ( 
 or 
 )] repeatedly until the station is tuned in.
4. Press and hold [ 
 , MEMORY] until the fre-
quency begins to change.
This will start presetting automatically. When finished, the radio
will tune in the last station memorized.
If auto presetting is not possible because radio signals are weak
or for some other reason, do the following.
Presetting only your favorite stations
Preset the stations one at a time.
1. Perform step 1 above. Then, press [ 
 , MEMORY] (“PRGM”
flashes) and select a station with [TUNE/TIME ADJ ( 
 or 
 )].
2. While “PRGM” is flashing press [ 
 , MEMORY] again and se-
lect a preset channel with [TUNE/TIME ADJ ( 
 or 
 )].
3. Press [ 
 , MEMORY] to preset the station.
Memory retention
The preset stations are retained in memory for about 2 weeks even if
the system is unplugged.
FM allocation settings:
This system comes equipped with an electronic digital tuner that di-
vides the broadcast band into many small steps. These steps match
the assignable broadcast frequencies and intervals in between.
Each country allocates broadcast bands according to their particular
needs.
By adjusting the allocation, you can enable the tuner to receive FM
broadcasts allocated in 0.1 MHz steps.
Press and hold [TUNER/BAND]. After a few seconds the display will
change to a flashing display of the current minimum frequency. If you
continue to hold [TUNER/BAND] down, the minimum frequency will
change. Release the button at this time.
To return to the original frequency indication, repeat above.
Note
After changing the allocation setting, the frequencies you previously
preset in the memory will be cleared.
1
2
3
4
1
2
4
3
Preset channel
Preparations