Panasonic SC-HC38 User Manual

RQT9742

As a factory preset, this unit will always turn off 
automatically if there is no sound output and no 
operation for approx. 30 minutes.
To cancel this function

Press [SETUP] repeatedly to select 
“AUTO OFF”.

Press [3, 4] to select “OFF” and then press 
[OK].

≥ To turn automatic standby on, select “ON” in step 2.
≥ This setting cannot be selected when “FM” is the source.

The brightness of this unit’s display can be 
changed.

Press [SETUP] repeatedly to select “DIMMER”.

Press [3, 4] to select “ON” and then press 
[OK].

To cancel the dimmer, select “OFF” in step 2.

When other Panasonic equipment responds to the 
supplied remote control, change the remote control 
code.

Press [CD] to select “CD”.

While pressing and holding [SELECTOR] on 
the unit, press and hold [CD/RADIO] on the 
remote control until the unit's display shows 
“REMOTE 2”.

Press and hold [OK] and [CD/RADIO] on the 
remote control for at least 4 seconds.

≥ To change the mode back to “REMOTE 1”, repeat the 

steps above but replace the button pressed on the 
remote control from [CD/RADIO] to [ ].

Before requesting service, make the following 
checks. If you are in doubt about some of the check 
points, or if the solutions indicated in the following 
guide do not solve the problem, refer to “Customer 
Services Directory (United States and Puerto Rico)” 
on page 19.

≥ An AC power supply cord or fluorescent light is near the 

cords. Keep other appliances and cords away from this 
unit’s cables.

≥ Make sure that the disc is compatible with this unit. 

(

l

14)

≥ There is moisture on the lens. Wait for about an hour 

and then try again.

≥ Confirm the FM antenna is properly connected. (

l

5)

≥ Adjust the position of the antenna.
≥ Try to keep a certain amount of distance between the 

antenna and AC power supply cord.

≥ Try using an outdoor antenna if there are buildings or 

mountains nearby.

≥ Switch the television or other audio players off or 

separate it from this unit.

≥ Keep this unit away from mobile phones if the 

interference is apparent.

To return all settings to the factory preset
When the following situations occur, reset the 
memory:

≥ There is no response when buttons are pressed.
≥ You want to clear and reset the memory contents.

1 Disconnect the AC power supply cord. (Wait 

for at least 3 minutes before proceeding to 
step 2.)

2 While pressing and holding down [

Í/I] on the 

unit, reconnect the AC power supply cord.
≥ “--------” appears on the display.

3 Release [

Í/I].

All the settings are returned to the factory preset. You will 
need to reset the memory items.

SC-HC38~RQT9742.book  Page 11  Tuesday, December 11, 2012  2:20 PM