Panasonic sl-pd7apc User Manual

13

RQT5763

When recording, the changer will automatically program the
tracks for tape sides A and B in accordance with the length of
the tape so that none of the tracks will be interrupted before
they are completed.
In addition, the program will also include a silent interval of
approximately 4 seconds between tracks.

Set the Dolby NR, reverse mode, recording level, etc., as in-
structed in the Operating Instructions for the tape deck.

Rewind the tape so recording is possible from its beginning.

Each time you press the button, the display showing the tape
length changes as follows.

C-46      C-60      C-90      C---

Choose the length of the tape you will use.

More precise time settings are also possible.
(Refer to “To enter a desired recording time other than 46, 60
or 90 minutes” below.)

The data of the tracks to be recorded is displayed as shown in
the diagram.
In this example, disc 5 can be recorded with tracks 1-4 on side
A and tracks 5-7 on side B of the cassette tape.

Start recording on the tape deck and then immediately:

When the last track set for recording on side A is finished, the
changer will enter the pause mode. Set the tape to the position
from which recording will begin on side B, and then perform
step 

 once again.

When all the programmed tracks on the specified disc finish
playing, the changer will automatically stop. The edit guide
mode will be cancelled at the same time.

1. Select “C---” in step 

.

2. Enter the total recording time in minutes (1-99) using the

numeric buttons.
For example
To use 52-minute tape, press [5] then [2].

You can also specify the tape length by pressing [

] or [

]

buttons.
Press either [

] or [

] from each step C-46, C-60, C-90 or C---.

For example
To use 52-minute tape, select C-46 and then press and hold [

]

until the display shows “52”.

The maximum allowable playing time for editing is 99 minutes.

Depending on the disc, a little of the beginning of the next track
may be recorded onto the end of the track.

SEC 

MIN

TRACK

DISC

TRACK

EDIT 

SEC 

MIN

EDIT 

TRACK

EDIT 

Specified disc number

Number of tracks 
to be recorded

Tracks to be 
recorded

Remaining time on side A

Number of tracks 
to be recorded

Tracks to be 
recorded

Remaining time on side B

SEC 

MIN

EDIT 

MIN

DISC

EDIT 

4

7

2

5

8

3

6

9

0

1

10

10

OPEN CLOSE

POWER

/ 

I

REPEAT

SPIRAL

RANDOM MODE

TIME MODE

EDIT  GUIDE

ID SCAN

PROGRAM MODE

DISC 1

DISC 2

DISC 3

DISC 4

DISC 5

DISC SKIP

EDIT  GUIDE

Side A (30 min)

Side B (30 min)

Track 1

Track 2

Track 3

Track 4

Track 5

Track 6

Track 7

Silent interval between tracks
(approx. 4 seconds)

Example: Recording from a disc containing seven tracks 

 onto a 60-minute tape.

DISC SKIP

DISC SKIP