Panasonic sx-pr54m User Manual
Part VIII
Sound Edit
119
QQTG0701
So
un
d E
d
it
6.
Repeat steps 2 to 5 for the other controllers,
as desired.
as desired.
7.
Use the GLIDE
∧
and
∨
buttons to select
whether or not the glide effect is active.
ENABLE:
The glide effect is enabled.
DISABLE:
The glide effect is disabled.
Store the new sound
The MEMORY button in the SOUND GROUP section accesses memory banks reserved for the sounds
you create with the SOUND EDIT. You can store up to 40 original sounds then select the sounds just like
the other sounds in the SOUND GROUP.
you create with the SOUND EDIT. You can store up to 40 original sounds then select the sounds just like
the other sounds in the SOUND GROUP.
Procedure
1.
When you have edited the sound to just the
way you like it, on the SOUND EDIT menu dis-
play press the WRITE button.
way you like it, on the SOUND EDIT menu dis-
play press the WRITE button.
• The display changes to the MEMORY WRITE display.
2.
To assign a name to your new sound, press
the SOUND NAMING button.
the SOUND NAMING button.
• If you do not assign a name to your sound, the name
becomes the same as the original sound from which you
started. In this case, skip to step 5.
started. In this case, skip to step 5.
• The display changes to the SOUND NAMING display.
3.
Use the buttons below the display to assign a
name.
name.
• Set the character input position with the POSITION but-
tons, select the characters with the alphanumeric buttons
and repeat name assignment.
and repeat name assignment.
• Switch from upper to lower case letters with the ABC, abc
button.
• Use the !#$ button to switch to the symbols character set.
• Press the INS button to enter a space at the cursor posi-
• Press the INS button to enter a space at the cursor posi-
tion.
• Press the DEL button to erase the character at the cursor
position.
• Press the CLR button to erase the entire name.
• Press the
• Press the
→← button to center the name.
4.
When you have finished typing the name,
press the OK button.
press the OK button.
• The display returns to the MEMORY WRITE display.
5.
Use the
∧
and
∨
buttons to select the MEM-
ORY number in which to store the new sound
(1–40).
(1–40).
6.
Press the OK button.
• The new sound is stored, and “COMPLETED!” is shown
on the display.
• The SOUND EDIT mode is turned off.
• The stored sound memories can be saved on a disk for
recall at a later time. (Refer to page 97.)
Select a new sound
You can select your original sound just like the
other sounds in the SOUND GROUP.
other sounds in the SOUND GROUP.
1.
In the SOUND GROUP section, press the
MEMORY button.
MEMORY button.
• The list of sounds is shown on the display.
2.
Select the desired sound from the list on the
display.
display.
MEMORY
13_Part VIII.fm 119 ページ ２００３年５月２０日 火曜日 午前８時２１分