Panasonic th 103vx200u User Manual

This unit has a network function to control the network connected display with your computer.
Note:
To use the network function, set each “NETWORK SETUP” setting and make sure to set the “CONTROL I/F SELECT” 
to “LAN”. (see page 55)
When “LAN” is set, power is supplied to LAN circuit, and power indicator is lit orange under the condition of power off 
with remote control (stand-by state).

Network function of the unit can control the unit in the same way as serial control from a network. 
Supported commands
Commands used in the serial control are supported. (see page 16)
Note:
Consult your local Panasonic dealer for detail instructions on command usage. 

Hub or broadband router

LAN cable

(not supplied)

•  Lay the LAN cable away from other connection cables (excluding the power cord).

•  Make sure the broadband router or hub supports 10BASE-T/100BASE-TX. 

•  To connect a device using 100BASE-TX, use “category 5” LAN cable. 

•  Touching the LAN terminal with a statically charged hand (body) may cause damage due 

to its discharge.

  Do not touch the LAN terminal or a metal part of the LAN cable. 
•  For instructions on how to connect, consult your network administrator.

COMPUTER

Clamper

Note:   In accordance with the Installation Instructions, secure the LAN cable so that it will not become near the 

display unit.

When using a pedestal (TY-ST85P12) for the installation of the display, use a clamper supplied 
with the display to secure the LAN cable. For use with another method of installation, refer to 
the corresponding Installation Instructions.