Sharp 27f541 User Manual

Press to turn the VCR or DVD 
on and off. 

Press to playback a tape or disc.

Press to rewind a tape or  
reverse a disc. For some VCRs   
or DVDs you may need to press    
STOP first, then REWIND.

Press to temporarily stop the 
tape or disc during playback 
or recording (VCR only). 
Press again to release PAUSE.

Press to stop the tape or disc.

Use to enter two-digit code
numbers when identifying your 
VCR, DVD and CATV converter. 

Press to rapidly advance the 
tape or disc. For some VCRs or 
DVDs, you may need to press 
STOP first, then FF.

Press to scan up or down through 
channels on the VCR.

Press to begin recording. 
(VCR only)

Press to jump forward to the 
beginning of the next chapter/track, 
or backward to the beginning of the 
current chapter/track, and 
automatically start to play that 
chapter/track.

With the purchase of your television set you
also have received the latest innovation in
remote control technology. With its easy-to-use
push button keyboard, your Remote can
control your television set and most infrared
remote controlled VCRs, cable TV converters
and DVDs as well.

• Depending on the model year produced, brand

and type of VCR, cable TV converter and DVD,
some models may not be compatible with the
remote control.

• Some brands may not enable channel

selection until the 

 is pressed. In such

case, try the following.

When you select channel 24,
(1) Press 

 “2”.

(2) Press 

 “4”.

(3) Press 

.

For detailed information on the use of the
Cable TV converter Box refer to their operating
manuals.

After installing the batteries, set the 

 on the Remote to the TV

position. (If you can change the channel of the
TV by pressing 

a

/

s

 on the Remote

Control, it is in the TV position.)

Your Remote Control has been set at the
factory to operate your TV and many remote
controlled VCRs, cable TV converters and
DVDs. However, in some cases an easy one-
time set-up step may be necessary before the
Remote will operate accessory VCRs, cable
TV converters and DVDs.

• In this set-up step, the Remote locates and

memorizes the remote control transmitter code
for the VCR, cable TV converters and DVDs.

• Once “identified”, the Remote sends proper

signals to operate your accessory.

• This identifying step will not have to be

repeated until power to the Remote is
interrupted due to a battery failure.

Once you make certain the Remote Control
has “identified” your remote controlled VCR or
DVD, the Remote is ready to operate your unit.
The various VCR or DVD function buttons on
the Remote will not operate your VCR or DVD
if those features are not already found on your
unit.

• All VCR buttons will operate whether the

Remote is in TV or VCR modes.

• For detailed information on the use of the VCR

or DVD, refer to the operation manual of the
VCR or DVD.

27F541

41