Panasonic th-32lhd7bk User Manual
8
Connections
VIDEO IN
AUDIO
IN
L
R
S VIDEO IN
SLOT 2
AV
VD
HD
PR/CR/R
PB/CB/B
Y/G
R AUDIO L
COMPONENT/RGB IN
SLOT 1
AUDIO
PC IN
SERIAL
VIDEO OUT
1
2
SERIAL
PC IN
AUDIO
SLOT1
SLOT2
VIDEO IN
VIDEO OUT
P
R
/C
R
/R P
B
/C
B
/B
Y/G
AUDIO
R
L
COMPONENT/RGB IN
AUDIO
IN
R
L
AV
S VIDEO IN
1
2
1
2
SPEAKERS
Terminals (R)
Terminals (R)
SPEAKERS
Terminals (L)
Terminals (L)
– Cable fi xing bands Secure any excess cables with bands as required.
When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker’s Installation Manual for details on speaker installation.
Refer to the speaker’s Installation Manual for details on speaker installation.
Pass the attached cable
fi xing band through the
clip as shown in the
fi gure.
fi xing band through the
clip as shown in the
fi gure.
To secure cables connected to Terminals, wrap the cable fi xing band around them
then pass the pointed end through the locking block, as shown in the fi gure.
While ensuring there is suffi cient slack in cables to minimize stress (especially
in the power cord), fi rmly bind all cables with the supplied fi xing band.
then pass the pointed end through the locking block, as shown in the fi gure.
While ensuring there is suffi cient slack in cables to minimize stress (especially
in the power cord), fi rmly bind all cables with the supplied fi xing band.
AV Terminals
(see page11)
AC cord connection (see page 12)
To tighten:
To loosen:
Pull
Pull
Push the catch
3. Slide up the clamper
and fi x the AC cord
plug securely.
plug securely.
2. Insert the AC cord and close
the clamper securely.
1. Open the clamper.
Clamper
AC cord
Note: The power plug in the illustration may not be the type fi tted to your set.
When loosen
the clamper:
the clamper:
– AC cord fi xing
COMPONENT/RGB IN
and Audio IN Terminals
(see page11)
Speakers (Optional accessories)
From EXTERNAL
monitor terminal on
Computer (see page 9)
From SERIAL Terminal
on Computer
(see page 10)
Note: At factory shipment, Terminal boards are installed in SLOT 1 and SLOT 2.
4. Insert the point of the
fi xed clamper into the
small hole on the lower
small hole on the lower
r i g h t o f
the back
cover as
necessary.
the back
cover as
necessary.