Panasonic th-50phd5uy User Manual

Notes:
(1) Computer signals which can be input are those with a horizontal scanning frequency of 15.6 to 110 kHz and vertical

scanning frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200
lines.)

(2) The display resolution is a maximum of 768 

×

 768 dots (TH-42PHD5) / 1,024 

×

 768 dots (TH-50PHD5) when the aspect

mode is set to “NORMAL”, and 1,024 

×

 768 dots (TH-42PHD5) / 1,366 

×

 768 dots (TH-50PHD5) when the aspect mode

is set to “FULL”. If the display resolution exceeds these maximums, it may not be possible to show fine detail with
sufficient clarity.

(3) The PC input terminals are DDC1/2B-compatible. If the computer being connected is not DDC1/2B-compatible, you will

need to make setting changes to the computer at the time of connection.

(4) Some PC models cannot be connected to the set.
(5) There is no need to use an adapter for computers with DOS/V compatible D-sub 15P terminal.
(6) The computer shown in the illustration is for example purposes only.
(7) Additional equipment and cables shown are not supplied with this set.
(8) Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specified

frequency range.

AUDIO

PC IN

COMPUTER

Conversion adapter 
(if necessary)

RGB

D-sub 15p

Stereo plug

PC cable

Connect a cable that matches
the audio output terminal on the computer.

POWER     /

R - STANDBY

G   POWER ON

INPUT

–   VOL      +

Less than

3" 

15

/

16

(10 cm)

Audio

Less than

3" 

15

/

16

(10 cm)

Ferrite core (small size)

(supplied)

Ferrite core (large size)
(supplied)

Installing the ferrite core (Small size)

Pull back the tabs
(in two places)

Open

Press the cable
through and close

Installing the ferrite core (Large size)

Pull back the tabs
(in two places)

Open

Press the cable
through and close