Panasonic th-50phw3 User Manual
14
Connections
How to connect the PC Input Terminals
Notes:
(1) Computer signals which can be input are those with a horizontal scanning frequency of 15.5 to 110 kHz and
(1) Computer signals which can be input are those with a horizontal scanning frequency of 15.5 to 110 kHz and
vertical scanning frequency of 48 to 120 Hz. (However, signals exceeding 1200 lines will not be displayed
properly.)
properly.)
(2) The display resolution is a maximum 640
×
480 dots when the aspect mode is set to “4:3”, and 852
×
480 dots
when the aspect mode is set to “16:9”. If the display resolution exceeds these maximums, it may not be possible
to show fine detail with sufficient clarity.
to show fine detail with sufficient clarity.
(3) The PC input terminals are DDC1/2B-compatible. If the computer being connected is not DDC1/2B-compatible,
you will need to make setting changes to the computer at the time of connection.
(4) Some PC models cannot be connected to the set.
(5) An adapter is required to use the PC cable (D-sub 15P) to connect a Macintosh computer to the set.
(6) There is no need to use an adapter for computers with DOS/V compatible D-sub 15P terminal.
(7) The computer shown in the illustration is for example purposes only.
(8) Additional equipment and cables shown are not supplied with this set.
(9) Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the
(5) An adapter is required to use the PC cable (D-sub 15P) to connect a Macintosh computer to the set.
(6) There is no need to use an adapter for computers with DOS/V compatible D-sub 15P terminal.
(7) The computer shown in the illustration is for example purposes only.
(8) Additional equipment and cables shown are not supplied with this set.
(9) Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the
specified frequency range.
Signal Names for D-sub 15P Connector
Pin Layout for PC Input
Terminal
Terminal
Pin No.
1
2
3
4
5
Pin No.
6
7
8
9
10
Pin No.
11
12
13
14
15
Signal Name
R
G
B
GND (Ground)
GND (Ground)
Signal Name
GND (Ground)
GND (Ground)
GND (Ground)
NC (not connected)
GND (Ground)
Signal Name
GND (Ground)
SDA
HD/SYNC
VD
SCL
1
6
7
8
3
9
4
5
10
15
14
13
12
11
2
AUDIO
PC IN
COMPUTER
Conversion adapter (if necessary)
Audio
RGB
D-sub 15p
1/8" (3mm) Stereo Plug
PC cable
Connect a cable which matches
the audio output terminal on the computer.
the audio output terminal on the computer.
POWER /
R - STANDBY
G POWER ON
INPUT
— VOL +