Panasonic th-50pb2w User Manual

Page of 64
INPUT
MENU
ENTER/
+/
VOL
-/
Power Indicator
Remote Control Sensor
14
Power On / Off
Connecting the AC cord plug to the Plasma Display.
Press the 
 button on the remote control to turn the Plasma Display off.
Power Indicator: Red (standby)
Press the 
 button on the remote control to turn the Plasma Display on.
Power Indicator: Green
Turn the power to the Plasma Display off by pressing the 
 switch on the 
unit, when the Plasma Display is on or in standby mode.
Note: 
During operation of the power management function, the power indicator turns 
orange in the power off state.
Connecting the plug to the Wall Outlet
Notes:
•  Main plug types vary between countries. The power 
plug shown at right may, therefore, not be the type 
fi tted to your set.
• When disconnecting the AC cord, be absolutely 
sure to disconnect the AC cord plug at the socket 
outlet fi rst.
Press the Power switch on the Plasma Display to 
turn the set on: Power-On.
Power Indicator: Green
[Starting up the network]
It takes some time for the network to start up just 
after the power is turned on.
During that time, “Network Setup” in the “Setup” menu 
is grayed out and cannot be set.