Panasonic tu-pta500u User Manual
14
Installation
PC-IN
S-VIDEO
MENU
POWER
R-STAND BY
G-POWER ON
G-POWER ON
ACTION INPUT
VOLUME
CHANNEL
VIDEO
INPUT 3
L-AUDIO-R
Notes:
(1) Computer signals which can be input are those with a horizontal scanning frequency of 15.5 to 110 kHz and vertical
(1) Computer signals which can be input are those with a horizontal scanning frequency of 15.5 to 110 kHz and vertical
scanning frequency of 48 to 120 Hz. (However, signals exceeding 1200 lines will not be displayed properly.)
(2) The display resolution is a maximum of 640
×
480 dots when the aspect mode is set to “NORMAL”, and 852
×
480
dots when the aspect mode is set to “FULL”. If the display resolution exceeds these maximums, it may not be
possible to show fine detail with sufficient clarity.
possible to show fine detail with sufficient clarity.
(3) Some PC models cannot be connected to the set.
(4) An adapter is required to use the PC cable (D-sub 15P) to connect a Macintosh computer to the set.
(5) There is no need to use an adapter for computers with DOS/V compatible D-sub 15P terminal.
(6) The computer shown in the illustration is for example purposes only.
(7) Additional equipment and cables shown are not supplied with this set.
(8) Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specified
(4) An adapter is required to use the PC cable (D-sub 15P) to connect a Macintosh computer to the set.
(5) There is no need to use an adapter for computers with DOS/V compatible D-sub 15P terminal.
(6) The computer shown in the illustration is for example purposes only.
(7) Additional equipment and cables shown are not supplied with this set.
(8) Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specified
frequency range.
Signal Names for D-sub 15P Connector
Pin layout for PC input
terminal
terminal
Pin No.
1
2
3
4
5
Pin No.
6
7
8
9
10
Pin No.
11
12
13
14
15
Signal Name
R
G
B
GND (Ground)
GND (Ground)
Signal Name
GND (Ground)
GND (Ground)
GND (Ground)
NC (not connected)
GND (Ground)
Signal Name
GND (Ground)
NC
HD / SYNC
VD
NC
1
6
7
8
3
9
4
5
10
15
14
13
12
11
2
Computer
Connect a cable which matches the
audio output terminal on the computer.
audio output terminal on the computer.
1/8” (3 mm) stereo plug
D-sub 15p
RGB
PC cable
Conversion adapter (if necessary)
How to connect the PC Input Terminals