Panasonic tu-pt600b User Manual

Your new set is supplied with programme position ‘0’ set to receive an RF signal from your VCR, although a Scart
connection is preferable if the VCR is so equipped (see page 10, 11 or 42 for suitable inputs to the Scart socket
on this set.)
However, if for some reason your VCR is tuned to a different RF channel then you will not receive any picture or
sound from your VCR on programme position ‘0’ of this set. Either adjust the tuning of this set’s programme
position ‘0’ (follow the instructions below) or adjust the RF channel of your VCR (some VCR’s allow adjustment of
their RF channel via their remote control unit) or both until the Television receives the RF output channel of your
VCR.
It is intended that this advice is used in conjunction with the instruction books for your additional equipment.

Switch on the VCR, insert and play a pre-recorded tape with known content.

   Press 

.

   Move to chosen Tuning menu option by using 

 or 

.

3 

  Access Tuning menu by using 

 or 

.

4 

  Move to chosen Manual tuning by using 

 or 

.

5 

  Access Manual tuning by using 

 or 

.

6 

  Select programme position ‘0’ VCR by using 

 or 

.

7 

  Start searching for the VCR playback of the known content tape by using

 or 

.

When the VCR playback is found, press 

 to store.

Pressing 

 to exit.

    21                                   68

Manual tuning

TV/AV
’STR’  Button   Store

E x i t

Serch
   down / up

Programme
   down / up

Return

CH44

VCR

The tape with known content
is found and displayed.
Pressing 

 will store the

setting.

Notes:
• If picture patterning occurs on programme position ‘0’ it may be necessary to adjust the RF output channel of the

VCR, refer to the VCR instruction book.

• If a Satellite Receiver and a VCR are going to be used with RF cable connections it is important to avoid both units

being set on the same channel.
Refer to the Satellite Receiver and VCR instruction books for precise tuning information.

VCR