Panasonic tx-26lxd50 User Manual
28
MENU
Commom Interface
1
2
3
4
5
6
7
8
9
0
IDTV
N
MODE
OK
C
EXIT
OK
Slot 1: No module inserted
Common Interface
Access
Switch on the TV.
In DVB mode
Press the MENU button.
Move to Setup menu.
Access Setup menu.
Move to DVB Setup menu.
Access DVB Setup menu.
Move to DVB System Setup.
Access DVB System Setup.
Move to Common Interface Module.
Access Common Interface Module.
Access the module.
Common Interface Module menu
(DVB mode)
The Common Interface Module menu provides access to software contained on Common Interface (CI) Modules.
These can be inserted in the “CI” slot located at the rear of the TV.
These can be inserted in the “CI” slot located at the rear of the TV.
IMPORTANT NOTES:
• Switch off the TV using the front panel switch before inserting or removing a module.
• If you are installing a TV software update, please follow the dedicated instructions supplied with the module.
• Insert / remove a module straightly to the CI slot.
• Switch off the TV using the front panel switch before inserting or removing a module.
• If you are installing a TV software update, please follow the dedicated instructions supplied with the module.
• Insert / remove a module straightly to the CI slot.
Insert the CI module:
Some Common Interface Modules may be a two piece design consisting
of a card reader together with the viewing card. When using this design
of card, first insert the card reader firmly into the CI slot on the TV.
Secondly, insert the viewing card into the reader.
Some Common Interface Modules may be a two piece design consisting
of a card reader together with the viewing card. When using this design
of card, first insert the card reader firmly into the CI slot on the TV.
Secondly, insert the viewing card into the reader.
If no module is inserted the message “No Module Inserted” will be
displayed.
(If you have inserted a module, check that it is fully inserted.)
displayed.
(If you have inserted a module, check that it is fully inserted.)
The features that now appear on screen are dependent on the contents
of the selected Common Interface Module.
Refer to the instructions supplied with the card or contact the vendor.
of the selected Common Interface Module.
Refer to the instructions supplied with the card or contact the vendor.
In all cases, it is possible to navigate the pages using buttons on the
remote control, but because the commands available must apply to all
manufacturers of DVB equipment, some on screen commands may not
correspond exactly to the remote control buttons.
remote control, but because the commands available must apply to all
manufacturers of DVB equipment, some on screen commands may not
correspond exactly to the remote control buttons.
For example:
For the on screen command ‘select’ or ‘go’, use the OK button.
For the on screen command ‘select’ or ‘go’, use the OK button.
If you see the
symbols, use the cursor keys.
If you see a line of key words displayed in red, green, yellow and blue,
use the coloured buttons to operate the functions.
use the coloured buttons to operate the functions.
The EXIT button should always allow you to exit the CI software.
English
3 seconds
Common Interface Module
System Update
DVB System Setup
Access
Display Timeout
Preferred Subtitles