Panasonic tx-68p200a User Manual
13
Picture Menu Operation
C. TEMP
The C. TEMP (Colour Temperature) control allows
you to change the White balance setting between
Standard, Warm and Cool.
you to change the White balance setting between
Standard, Warm and Cool.
Use the or buttons to switch between settings.
P-NR
The P-NR (Picture Noise Reduction) system is
designed to reduce picture noise during poor
quality reception conditions. Pushing the left or
right buttons will change the setting between OFF,
STRONG, WEAK and AUTO.
designed to reduce picture noise during poor
quality reception conditions. Pushing the left or
right buttons will change the setting between OFF,
STRONG, WEAK and AUTO.
Use the or buttons to switch between settings.
AI
When the AI (Artificial Intelligence) is turned on it
continually and precisely detects fine differences in
the picture signal. It also detects the differences in
the brightness, black level and contrast levels.
continually and precisely detects fine differences in
the picture signal. It also detects the differences in
the brightness, black level and contrast levels.
Use the
or buttons to switch the AI on or off.
SCAN MODE
The SCAN MODE control allows you to change
the Picture refresh setting between AUTO, 100Hz
MODE and PROGRESSIVE.
the Picture refresh setting between AUTO, 100Hz
MODE and PROGRESSIVE.
Use the or buttons to switch between settings.
AUTO
The TV software will select the best mode for the signal being
viewed.
viewed.
100Hz MODE
100Hz will give a steady picture for most signals.
PROGRESSIVE
Recommended when receiving NTSC signals.
Switching is also possible using the
button on the remote control.
Normalisation
N
Pushing the Normal (
) Button on the remote control, when the Picture Menu is displayed will return all
picture settings to the factory preset levels. This is called “Normalisation”.
Normalisation will not occur if the Picture Menu is not displayed when the Normal (
Normalisation will not occur if the Picture Menu is not displayed when the Normal (
) Button is Pushed.
Note:
We recommend that you set the SCAN MODE to PROGRESSIVE when viewing a PAL 60 or NTSC
transmission. When viewing a PAL transmission (other than PAL 60) with the SCAN MODE set to
PROGRESSIVE, the screen will flicker. This is not a fault.
transmission. When viewing a PAL transmission (other than PAL 60) with the SCAN MODE set to
PROGRESSIVE, the screen will flicker. This is not a fault.
PICTURE
AI
ON
SCAN MODE
AUTO
PICTURE
AI
ON
SCAN MODE
AUTO
PICTURE
MENU
DYNAMIC
CONTRAST
BRIGHTNESS
COLOUR
SHARPNESS
NTSC-TINT
C. TEMP
BRIGHTNESS
COLOUR
SHARPNESS
NTSC-TINT
C. TEMP
STANDARD
P-NR
AUTO
PICTURE
MENU
DYNAMIC
CONTRAST
BRIGHTNESS
COLOUR
SHARPNESS
NTSC-TINT
C. TEMP
BRIGHTNESS
COLOUR
SHARPNESS
NTSC-TINT
C. TEMP
STANDARD
P-NR
AUTO