Panasonic ty-42tm4z User Manual

Terminal name
indication label

Rear of Plasma Display

Affixing location

After completing installation of the Terminal Board, affix the included Terminal name indication label to the Plasma
Display.

To affix the label:

 Peel off the rear protective sheet of the Terminal name

indication label.

 For Plasma Display models to which a label is already

affixed, position the Terminal name indication label on
top of that label.

For models to which a label is not yet attached, affix the
Terminal name indication label while aligning with the molded
label locating marks, as shown in the figure.

For some models of the Plasma
Display, a label is already affixed.

Before installation

• Turn the power switch off and pull out the plug.
• Disconnect any plugs connected to the Plasma Display.

Place the Plasma Display upside down on a soft sur-
face, such as a foam mat.

Secure using the 4 screws removed at step 2 above.
Tighten screws in the numbered order ( 

 – 

 ).

Remove the 4 screws securing the slot cover or a
currently installed terminal board and remove the
cover or terminal board.

Note : The 4 screws are required for reassembly so

should be retained.

Confirm that the Terminal Board is correctly orientated
then carefully and slowly insert into the slot.
Ensure that the Board is completely seated.

Foam mat or thick
soft cloth

Note : Retain the cover or terminal board that has been removed in a safe location for potential future use.

Terminal name
indication label

Terminal name
indication label

Molded marks for label location

Molded marks

Molded marks