Panasonic wj-hd220 User Manual

40

● Alarm Data (ALARM DATA) (exclusive

The recorder pauses before sending a notice to the con-
nected system controller when an alarm operates.

1. Move the cursor to ALARM DATA with the [D] or [C]

button.

2. Select the parameter with the JogDial, and press the

JogDial.
The default is 1S.

OFF: Select this when no system controller is connect-

ed.

0S: Does not pause.
1S: Pauses 1 second.
5S: Pauses 5 seconds.

● Camera System Setup (CAMERA

This menu is provided for camera related setups such as
camera numbers, cable loss compensation, and data com-
munications. Cable loss compensation and data communi-
cation setups are not applicable to cameras 5-8, because
only cameras connected to VIDEO IN 1-4 can communicate
with the recorder via the coaxial cable.

1. Move the cursor to CAMERA SYSTEM SETUP and

press the JogDial.

2. Move the cursor to a camera and press the JogDial.

The cursor moves to the NUM (camera number) col-
umn.

3. Select a number by rotating the JogDial. 

The default is the same as the camera port numbers 1-
8. 

Assignable numbers: 001-128

4. Press the JogDial. The cursor moves to the COMP

(compensation) column.

5. Select an appropriate compensation parameter

depending on the cable distance by rotating the
JogDial. Selection is applicable to CAM 1-4 only.

The default is S (short distance). M stands for medium
and L for long.

≤ 500 m

M: 500 m – 900 m
L: 900 m – 1 200 m

6. Press the JogDial. The cursor moves to the DATA col-

umn.

7. Select ON or OFF with the JogDial and press the

JogDIal. Selection is applicable to CAM 1-4 only.
The default is ON.

ON: Enables data communications by use of PSD com-

mands multiplexed on the coaxial cable.

OFF: Disables coaxial-multiplexed communications.
Note:  Selecting OFF is recommended when cameras

having no PSD communications are connected.

8. Repeat steps 2-7 above for other cameras.

9. Press the [SETUP/ESC] button to go back to the SERI-

AL PORT SETUP.

■ Network Setup (NETWORK

Note: The system will restart after the menu setup window

is closed when any parameter in this window has been
changed.

● Line Speed (LINE SPEED)

1. Move the cursor to LINE SPEED with the [D] or [C]

button.

2. Select the parameter with the JogDial, and press the

JogDial.
The default is AUTO.

AUTO: The speed is automatically selected.
100M_FULL: 100 mega byte, full duplex
100M_HALF: 100 mega byte, half duplex
10M_FULL: 10 mega byte, full duplex
10M_HALF: 10 mega byte, half duplex 

→    001  S     ON

→    002  S     ON

→    003  S     ON

→    004  S     ON

→    005  

→    006       

→    007       

→    008       

→   00080

→192.168.000.010

→255.255.255.000

→192.168.000.001