Panasonic wj-fs109 User Manual

TITLE SETUP MENU

CH TITLE
1 1·······
2 2·······
3 3·······
4 4·······
5 5·······
6 6·······
7 7·······
8 8·······
9 9·······

2/2

TITLE SETUP 1/2

CH TITLE
1 1·······
2 2·······
3 3·······
4 4·······
5 5·······
6 6·······
7 7·······
8 8·······

2. Move the cursor to the title (TITLE) you want to edit.
3. Select the first character for the title by pressing the

Increment (+) or Decrement (–) button.
Characters for the title appear in the order shown
below.

3. Press the

MENU/ESC

button to execute the selection

and return to the SYSTEM SETUP menu.

3. CAM SW LOSS

This item lets you select whether to display “SW LOSS“
warning on the monitor when the camera switching pulse is
not supplied from the VTR.

Notes:

• This selection is effective only when the Recording

Mode in the Record Output Setup Menu is set to EXT.

• To reset the warning, press the

ALARM RESET

button,

or reconnect the CAMERA SW IN connector.

1. Move the cursor to the CAM SW LOSS parameter.
2. Select ON or OFF by pressing the

–

button.

The initial factory setting is ON.

ON:

Enables the display (SW LOSS) on the monitor

screen.

OFF:

Disables the display.

4. PLAYBACK AUTO

This item lets you enable or disable the PLAYBACK AUTO
mode. When PLAYBACK AUTO is set to ON, the pictures
displayed on the monitor correspond to the mode of the
VTR without the

VTR/CAM

button being pressed. Playback

pictures are displayed when the VTR is in playback mode
and camera pictures when the VTR is in non-playback
mode.

1. Move the cursor to the PLAYBACK AUTO parameter.
2. Select ON or OFF by pressing the

–

button.

The initial factory setting is ON.

ABCDEFGHIJKLM
NOPQRSTUVWXYZ
ÄÜÖÆÑÅ
0123456789

←→

=?’”#&()

-./:;.

(space mark)

<WJ-FS116>

<WJ-FS109>

4. After selecting the first character, press the B button.

Then select the second character.

5. Repeat steps 3 to 4 above to complete the title.
6. Repeat steps 2 to 5 to edit the titles of other channels.
7. Press the

MENU/ESC

button to finalize the character

selection. The title is set, and the display returns to
SYSTEM SETUP.

To erase a specific character

1. Select a character to be erased.
2. Select “•” (space mark) to erase the character.

To erase the title of a specific channel

1. Move the cursor to the channel number whose title is to

be erased.

2. Hold down

–

and

buttons simultaneously for 2 sec-

onds or more.

2. TITLE POSI

This item lets you select the position on the monitor where
the camera title is displayed. The initial factory setting
places the title at the bottom centre of the monitor screen.

1. Move the cursor to TITLE POSI parameter, then press

the

SET

button. The position setting menu appears on

the monitor screen.

2. Move the title by pressing the cursor (C, D, A, B) but-

tons.

CAMTITLE