Panasonic wj-fs109 User Manual

18

Enables the PLAYBACK AUTO mode.

Disables the PLAYBACK AUTO mode.

Set to OFF when a WJ-DR200 AV Disc Recorder

is connected to the unit.

This item lets you select whether to permit free or limited
access to the Setup menus. When PASSWORD is set to
ON, the operator must enter the password to access the
menus. Enter a 4-digit password consisting of numbers
from 1 to 9 (except 0).

1. Move the cursor to the PASSWORD parameter.
2. Select ON or OFF by pressing the 

or 

button.

The initial factory setting is OFF.

→

Password required to access the Setup menus.

1. Select ON by pressing the 

or 

button.

2. Move the cursor to the desired (first) digit by press-

ing the A or B button.

3. Select the desired number by pressing the 

or 

button.

4. Repeat steps 2 and 3 until all digits are registered.

No password required to access the Setup

menus (access is free).

If PASSWORD parameter is set to ON, the operator is
requested to type the password to access the Setup
menus.

1. Press the 

button for 2 seconds or more.

The password inquiry screen prompts you to type the
password.

2. Type the 4-digit password by pressing the 

buttons 1 through 9, and the A or B button.

3. The Setup menu appears if the typed password is cor-

rect. If a wrong password is typed, the screen displays
“NG” and returns to the screen before the 

button was pressed.

4. To retry repeat steps 1 and 2.

The password currently registered can be changed as fol-
lows.

1. Press the 

button for 2 seconds or more to

display the  password inquiry screen. Then type in the
current password by pressing the 

buttons, and the A or  B button. The SETUP menu
appears.

2. In the SYSTEM SETUP menu, select ON for the PASS-

WORD parameter.

3. Move the cursor to the first (desired)  digit  by pressing

the A or B button.

4. Select the desired number by pressing the 

or 

but-

ton.

5. Repeat step 3 and 4 until all digits are registered.
6. After registration the new password is required when

the operator accesses the SETUP menus.

This parameter lets you select a display pattern for your
startup screen. When the power is turned on, the picture is
displayed in the selected pattern.

1. Move the cursor to the PWR ON MODE parameter.
2. Select 1-16 (1-9 for WJ-FS109) or SPOT SEQ. The initial

factory setting is 1.

Spot picture of selected channel is displayed.

10-16 are not available for WJ-FS109.

A sequence of spot pictures is displayed.

This item lets you enable or disable the 

Selection

button. Select ON to protect the REC OUT signal from
being interrupted by accidental operation of the 

Selection button.

1. Move the cursor to the VTR KEY LOCK parameter.
2. Select ON or OFF by pressing the 

or 

button.

The initial factory setting is OFF.

Disables 

Selection button.

Enables 

Selection button.

The 

Selection button is also disabled

when PLAYBACK AUTO is set to ON.

This item lets you adjust parameters for playing back 
tapes that are recorded on a Panasonic system or a non-
Panasonic system.

1. Move the cursor to the ENCODE parameter.
2. Select PANA or OTHERS by pressing the 

or 

button.

The initial factory setting is PANA.

Select this, if the tape was recorded on a

Panasonic Multiplexer system.

Select for non-Panasonic system.