Panasonic wj-sx650p User Manual

Time Adjust Input

Time Adjust Output

37

Alarm Output 1 to
32

Until reset

Open Collector output,
24 V, 100 mA maximum

Alarm Recover
Input 1 to 16

100 or more
ms

Non-voltage make con-
tact output

1 second

• Open Collector out-

put, 24 V, 100 mA
maximum

• Signal is output every

hour on the hour.

100 or more
ms

• Non-voltage make

contact input

• Signal input is accept-

ed by up to ± 30 sec-
onds every hour on
the hour.
Time is adjusted on
the hour.

Note: "Alarm Recover Input 1 to 16" can be used as "Alarm

Monitor Reset". (Refer to p. 68.)

■ System Status Check

During connection procedures, system status can be
checked on 4 monitors.

The following examples are procedures to display the sys-
tem status on Monitor 1 to 4.

● WV-CU950/650

1. Select one of Monitor 1 to 4. (Refer to p. 57 Monitor

Selection.)

2. Press the MENU button repeatedly until "System Status"

appears on the LCD.

3. Press the F1 button. SYSTEM STATUS will be displayed

on Monitor 1 to 4.

Note: SYSTEM STATUS is displayed on a set of 4 monitors

(Monitor 5 to 8, Monitor 9 to 12...Monitor 29 to 32).

● WV-CU360C/CJ

1. Select one of Monitor 1 to 4. (Refer to p. 57 Monitor

Selection.)

2. Press the OSD and SYS S buttons at a time. SYSTEM

STATUS will be displayed on Monitor 1 to 4.

Note: SYSTEM STATUS is displayed on a set of 4 monitors

(Monitor 5 to 8, Monitor 9 to 12...Monitor 29 to 32).

MON: Monitor number
LCN: Camera number or recorder number
MODE: Display mode of the monitor
• SETUP: System Setup
• HISTORY: Alarm History Display
KB: System controller or PC
OPE: User ID of the operator or timer event No.
PRI: Operator priority

• When SETUP MENU is displayed, "0" appears on

this area.

• During monitor lock, this area is highlighted.

• Even while SYSTEM STATUS is being displayed on

monitors, normal operations and alarm control are avail-
able. However, you cannot check the camera or record-
ed images because black screen is displayed. It is rec-
ommended to use these monitors only to check SYS-
TEM STATUS.

• Up to 100 records of SYSTEM STATUS are saved in the

system. These records can be transmitted between PC
and this unit. (Periodical transmission is also available.)
For transmission, perform the serial command settings
in "Communication" – "Serial Command" of WJ-SX650
Series Administrator Console.

• To transmit SYSTEM STATUS records from the PC, refer

to Serial (RS-232C) Connector Command Reference
(PDF file on the supplied CD-ROM).

LCN, MODE, KB and OPE parameters are highlighted 
for monitors during the alarm mode status.

LCN and MODE parameters are highlighted for monitors 
during the alarm ACK status.