FIC mb02 Service Manual

Page of 9
 
Installation and Upgrade 
 
2-8 
FIC MB02 Service Manual 
 
Using the Memory Slot inside the Memory Compartment 
Follow the steps below on how to upgrade the memory modules:  
 
1.  Make sure the system is powered off and that no peripheral devices are attached. 
 
2.  Turn the system over and locate the screw on the memory compartment. 
 
3.  Remove the K/B cover, K/B and Middle plate. 
 
4.  Locate the memory module socket. Align the notch with the notch in the socket connector 
and insert the module as follows: 
− 
Hold the DIMM at a 60-degree angle and align the DIMM connector with the 
socket in the system. Push the connector into the socket. 
− 
Press down on the edge of the DIMM until the locking tabs on the sides snap into 
place, securing the module. 
 
 
5.  To remove a DIMM, press the locking tabs away from the sides of the module until the 
module pops up. Then, remove the DIMM. 
 
6.  Reassemble the notebook components as follows. 
− 
Put the DIMM door back. 
− 
Replace the screw and turn the system over. 
2.3.4  Hard Disk Upgrade Procedure 
The notebook provides a built-in hard disk for the primary IDE controller. The HDD is an 
industry standard 2.5” IDE disk drive and can be upgraded with another standard 2.5” HDD. 
 
1.  Make sure the system is powered off and that no peripheral devices are attached. 
 
2.  Remove the four screws. 
 
 
 
Figure 2-8   Remove HDD module 
 
 
PDF created with FinePrint pdfFactory trial version