Panasonic wv-cu360 User Manual

18

■

The following function is available only when connected to
System Units.
There are two ways of system unit selection. One is to enter
unit address using numeric buttons and the other is to
select a system unit by pressing the UNIT A/UNIT or UNIT
B button.

●

1. Check the unit number of each system unit.
2. Enter a unit number using numeric buttons.

3. Press the 

button after pressing the 

button.

The selected unit number appears in the unit section of
the LED display.
The selected camera number appears in the camera
section of the LED display.

• To confirm the selected unit number when the moni-

tor number appears in the unit section of the LED
display, take procedure 3 or press MON/ESC but-
ton .

• If no unit is connected, [Err] appears a few seconds

after unit selecting operation is performed. In such
a case, repeat the above procedures after confirm-
ing the unit address.

• If the unit address of a system unit is unknown, con-

sult the unit's administrator.

• When multiple system units such as Data Multiplex

Unit are connected to the System Controller and the
UNIT A/UNIT button is pressed, the camera number
on the controller's LED display will not agree with
the camera picture on the monitor.
In this case, select the monitor and camera as
described on the next page.

●

The UNIT A/UNIT button or UNIT B button can be assigned
each till nine system units using Numeric buttons.
These buttons can be assigned to system units using the
Setup menu (See page 12).
If two or more system units are connected, the desired one
can be selected by pressing the corresponding numeric
button, then press the UNIT A/UNIT button or UNIT B but-
ton.

1. Enter an UNIT A or UNIT B number using numeric but-

tons.
This operation can be omitted if you select the unit
assigned to UNIT A number 1 or UNIT B number 1.

2. Press the 

button or the 

button.

The selected unit address appears in the unit section of
the LED display.
The selected camera number appears in the camera
section of the LED display.

• In cases where the system unit is frequently used,

assign the UNIT A number [UA-no] or the UNIT B
number [Ub-no] (See page 12).

• If [A1-**] or [b1-**] is assigned to the system unit

as its UNIT A or UNIT B number, it can be selected
by simply taking procedure 2.
[**] displays the selected unit address (01-99)

• When multiple system units such as Data Multiplex

Unit are connected to the System Controller and the
UNIT A or UNIT B button is pressed, the camera
number on the controller's LED display will not
agree with the camera picture on the monitor.
In this case, select the monitor and camera as
described on the next page.