Panasonic wv-cu360 User Manual

19

■

Check that a monitor is connected to the system unit cor-
rectly and securely.

1. Select a system unit connected to the monitor.

2. Enter the monitor number using numeric buttons.

A monitor number is setup each system unit for output
to the monitors. For further information, refer to the
Operating Instructions for the individual units.

3. Press the 

button.

The selected monitor number appears in the monitor
section of the LED display. And then you can control
video operation for the selected monitor.
The selected camera number appears in the camera
section of the LED display.

• To confirm the selected monitor number, simply

take procedure 3 when the unit address appears in
the monitor section of the LED display.

• The display of the unit section and the monitor sec-

tion of the LED display changes alternately every
time the MON/ESC button is pressed.

• The setting is invalid if the unit in which a monitor

number has been set is not programmed.

• In the above case, repeat the same procedure after

confirming the monitor number. If you do not know
the monitor number, consult the administrator of it.

• When [--] appears in the monitor section of the LED

display, the selected system unit is not compatible
with the Monitor Selection.

• For further information, refer to the Operating Inst-

ructions for the system unit concerned.

■

1. To display the selected camera, select the desired sys-

tem unit connected to cameras and the monitor.

2. Press the numeric buttons for the selected camera

number.
The camera number appears on the LED display.

3. Press the 

button to display the picture of the

selected camera.

The following function are available after selecting a cam-
era.

• Pan/tilt
• Focus
• Zoom
• Iris
• Defroster ON/OFF (for camera housing)
• Wiper ON/OFF (for camera housing)
• Preset Position (for Combination Camera)
• Home position (for Combination Camera)
• Colour or B/W picture changing function (for

Combination Camera)

• Auto pan (for Combination Camera)
• Patrol Learn function (for Combination Camera)
• Camera functions (for Combination Camera)

[--] appears in the camera section of the LED

display when an alarm is activated, when the multi-
screen is displayed, or when sequence mode is on.

The following function is available only in cases where sys-
tem units with the picture change function are connected.

• The currently selected camera can be replaced with the

camera of the next higher number by pressing the EL-
ZOOM/+ button after pressing the SHIFT button.

• The currently selected camera can be replaced with the

camera of the next lower number by pressing the
STILL/– button after pressing the SHIFT button.

MON

CAM

LOGOUT

ESC

SET