Panasonic wv-cu360 User Manual
20
4. Press the
EL-ZOOM/+
but-
ton again to zoom. The
zoom area can be moved
by the joystick in zoom
mode.
zoom area can be moved
by the joystick in zoom
mode.
CONTROLLING SYSTEM FUNC-
TIONS
TIONS
It is necessary to setup the system unit compatible with
Panasonic Security Data mode before using system
functions.
Panasonic Security Data mode before using system
functions.
For further information, refer to the Operating
Instructions for the system unit. You can also setup the sys-
tem unit by this controller (See page 28). The operation dif-
fers depending on the system unit.
tem unit by this controller (See page 28). The operation dif-
fers depending on the system unit.
●
Multiscreen Selection
The following function is available only in cases where sys-
tem units with the multiscreen function are connected.
tem units with the multiscreen function are connected.
1. Select the desired system unit and monitor.
2. Press the
MULTISCREEN SELECT
button.
EL-ZOOM
+
3. Move the [+] mark into the
zoom area by moving the
joystick.
joystick.
3. To cancel the still function, repeat procedures 1
and 2 above.
●
Electronic Zoom Control
The following function is available only in cases where sys-
tem units with the electronic zoom control function are con-
nected.
tem units with the electronic zoom control function are con-
nected.
1. Select the desired system unit, monitor and camera.
2. Press the
EL-ZOOM/+
button. The
EL-ZOOM/+
indica-
tor lights up and the [+] mark appears at the center of
the monitor screen.
the monitor screen.
MULTI SCREEN SELECT
¢
`
@
@@
@
1
2
3
4
Example of Quad Picture
UP
L
R
DOWN
3. A multiscreen appears. Each time the
MULTISCREEN
SELECT
button is pressed, the multiscreen changes.
The number of multiscreen pictures differ depending on
each system unit.
each system unit.
Note:
This function is invalid unless a multiscreen moni-
tor is selected.
●
Still Function
The following function is available only in cases where sys-
tem units with the still function are connected.
tem units with the still function are connected.
1. Select the desired system unit, monitor and camera.
2. Press the
STILL/–
button to freeze the picture.
The
STILL/–
indicator lights up.
STILL
–
3. To cancel the still function, press the
STILL/–
button
again.
STILL
–
Notes:
• To freeze only a specific camera picture on the multi-
screen
1. Select the desired system unit and monitor.
2. Select a camera number using numeric buttons.
3. Press the
2. Select a camera number using numeric buttons.
3. Press the
STILL/–
button.
4. To cancel the still function, repeat procedures 2
and 3 above.
• To freeze all camera pictures on the multiscreen
1. Press numeric button
0
.
2. Press the
STILL/–
button.
STILL
–
STILL
–
0