Panasonic wv-cu360 User Manual

27

■

When the WV-CU360 receives an alarm signal from a sys-
tem unit, the alarm indicator blinks.
The alarm indicator changes from blinking to steady light
when the alarm is automatically reset.
The camera number [---] appears in the camera section of
the LED display.

■

1. Press the 

button.

The alarm indicator goes off.

• Alarm reset operations (including auto reset) apply

to the whole system comprising the multiple system
units, not to a selected unit alone.

• Alarm reset mode differs depending on the system

unit connected to the WV-CU360 when an alarm is
reset.

• Confirm that the SHIFT button is released.

■

The following function is available only in cases where sys-
tem units with the alarm suspend function are connected.

1. Press 

button. The 

indicator lights up.

PROGRAM

PRESET

ESC

HOME

SET

PRESET

The System Controller WV-CU360 can be reset to the
default settings as follows:

1. Turn the controller's power off (unplug the DC plug of

the AC adapter).

2. Plug in the DC plug of the AC adapter connected, while

pressing numeric buttons 

, 

and 

simultaneously.

3. When all indicators light up, resetting is completed.

Keep the DC plug of the supplied AC adapter

connected to the DC 9V Input Jack until all resetting
completes.

2. To cancel the alarm suspend function, press the 

button again.

Alarm suspension applies to the whole system

comprising the multiple system units, not to a
selected unit alone.

■

The following function is available only in cases where sys-
tem units with the alarm recall function are connected.

1. Select the desired system unit and monitor.

2. Press 

button after pressing

the 

button. The 

indicator lights

up. An alarm recall log appears on the monitor.

3. To cancel the alarm recall function, press the 

button after pressing the 

button again.

Input alarm is ignored even after the ALM SUSPEND is
set.