FIC a440 Service Manual
Installation and Upgrade
2-4
FIC A440 Series Service Manual
7. The installation program will automatically copy the DVD-ROM driver to your hard disk
and modify the AUTOEXEC.BAT and CONFIG.SYS files in activating the DVD-ROM
drive every time you boot the system up.
drive every time you boot the system up.
Installing the MKE DVD-ROM driver under DOS prompt
1. Boot up the system of your computer and insert the MKE DVD-ROM driver diskette into
the floppy drive.
2. Change the directory of the DOS prompt to Drive A and run the DVD-ROM installation
program by typing the command A:\>INSTALL.
3. The Easy Installation menu will appear and ask you to select type of installation. Input
<2> and press <Enter> to select Express Installation.
4. Press <Y> to confirm that Autoexec.bat is updated with Mscdex.exe.
5. The installation program will automatically copy the DVD-ROM driver to your hard disk
and modify the AUTOEXEC.BAT and CONFIG.SYS files in activating the DVD-ROM
drive every time you boot the system up.
drive every time you boot the system up.
You may also install Windows 98 by first installing the DVD-ROM / CD-ROM
driver under a pre-formatted hard disk with MS-DOS operating system. Then go
to Drive D (where the DVD-ROM / CD-ROM drive is assigned), and run
“SETUP.EXE” to install Windows 98.
driver under a pre-formatted hard disk with MS-DOS operating system. Then go
to Drive D (where the DVD-ROM / CD-ROM drive is assigned), and run
“SETUP.EXE” to install Windows 98.
It is important that you use the DVD-ROM / CD-ROM driver provided together
with the notebook. Using other DVD-ROM / CD-ROM driver may not allow
Windows 98 to shutdown properly.
with the notebook. Using other DVD-ROM / CD-ROM driver may not allow
Windows 98 to shutdown properly.
Installing Windows 98 from DVD-ROM / CD-ROM
After installing DVD-ROM / CD-ROM driver, you may insert Windows 98 disc into your
DVD-ROM / CD-ROM drive and run “Setup.exe”.
Installing Windows 2000 / NT from DVD-ROM / CD-ROM
If you are installing Windows 2000 or NT 4.0, you only need to set the boot sequence under
the Boot menu of the BIOS SETUP program to “ATAPI CD-ROM Drive”. Insert the
Windows NT compact disc into the CD-ROM or drive and boot directly from the disc for
immediate installation.
2.2.3 Installing the VGA Device Driver
Your notebook computer uses the high-performance Trident CyberBLADEi1 VGA controller,
which is an AGP 2x video local bus, 2D/3D Graphic Engine and includes Zoomed Video
(ZV) Port Technology for supporting ZV PCMCIA cards. Following is the procedure for
installing the VGA Driver for Windows 98 and NT 4.0:
Installing VGA Device Driver for Windows 98
1. Insert the CD containing the VGA driver for Windows 98 into CD-ROM drive.
2. Click
which is an AGP 2x video local bus, 2D/3D Graphic Engine and includes Zoomed Video
(ZV) Port Technology for supporting ZV PCMCIA cards. Following is the procedure for
installing the VGA Driver for Windows 98 and NT 4.0:
Installing VGA Device Driver for Windows 98
1. Insert the CD containing the VGA driver for Windows 98 into CD-ROM drive.
2. Click
the
Start button, and then click Control Panel.