DELL 200 User Manual
74
Removing and Installing Parts
Drive Interface Connectors
Most interface connectors are keyed for correct insertion; that is, a notch or a missing pin on one
connector matches a tab or a filled-in hole on the other connector. Serial ATA cables go to the pin-1
end of the connector. The pin-1 end of a connector on a board or a card is usually indicated by a
silk-screened “1” printed directly on the board or card.
connector matches a tab or a filled-in hole on the other connector. Serial ATA cables go to the pin-1
end of the connector. The pin-1 end of a connector on a board or a card is usually indicated by a
silk-screened “1” printed directly on the board or card.
NOTICE:
When you connect an IDE interface cable, do not place the colored stripe away from pin 1 of
the connector. Reversing the cable prevents the drive from operating and could damage the controller,
the drive, or both.
the drive, or both.
Power Cable Connector
To connect a drive using the power cable, locate the power input connector on the system board.
Connecting and Disconnecting Drive Cables
When removing an IDE drive data cable, grasp the colored pull-tab and pull until the connector
detaches.
detaches.
When connecting and disconnecting a serial ATA data cable, hold the cable by the black connector at
each end.
each end.
Serial ATA Connector
interface cable
interface connector
power cable connector
power input
connector
connector