Gateway 7001 Series User Manual

www.gateway.com

The power output of the AP is well below the RF exposure limits as known at this time. Because this wireless 
device emits less energy than is allowed in radio frequency safety standards and recommendations, Gateway 
believes these devices are safe for use.

Regardless of the power levels, care should be taken to minimize human contact during normal operation.

Measurements have been performed to show that the RF exposure is below what is considered safe limits; 
however care should be taken to make sure the user or bystanders keep the transmitter away from their body 
when the wireless device is transmitting. The transmitting antenna should be installed and used in a manner to 
maintain 20cm (8 inches) from user’s or bystander’s bodies.

This wireless device is intended to be used indoors. In some areas, use of this device outdoors is prohibited.

Operation of this device is subject to the following two conditions: (1) This device may not cause harmful 
interference, and (2) this device must accept any interference received, including interference that may cause 
undesired operation of the device.

This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 
of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a 
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not 
installed and used in accordance with the instructions, may cause harmful interference to radio or television 
reception. However, there is no guarantee that interference will not occur in a particular installation. If this 
equipment does cause interference to radio and television reception, which can be determined by turning the 
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following 
measures:

■

Reorient or relocate the receiving antenna

■

Increase the separation between the equipment and receiver

■

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

■

Consult the dealer or an experienced radio/TV technician for help.

Compliance Accessories: These accessories are required to be used in order to ensure compliance with FCC rules: 
The AC Adapter supplied with the device.

Wireless Channels: Gateway declares that the Gateway 7001 802.11 A+G Wireless Access Point is limited to 
channels 1 through 11, specified by firmware controlled in the USA.

In order to comply with FCC requirements this transmitter must not 
be operated (or co-located) in conjunction with any other transmitter 
or antenna. 

Wireless devices are not user serviceable. Do not modify them in any 
way. Modification to a wireless device will void the authorization to 
use it. Please contact Gateway for service.