Gateway 7450R User Manual
24
Gateway 7450R Server System Manual
Installing a CD drive
The CD drive bay is in the center of the front panel. If the server did not
include a CD drive, a blank or “dummy” unit occupies the bay and must be
removed.
include a CD drive, a blank or “dummy” unit occupies the bay and must be
removed.
To install your CD drive assembly:
1
Turn off the system and disconnect the power cord and all other external
peripheral devices.
peripheral devices.
2
Open the case. See “Opening the case” on page 18 and “Preventing static
electricity discharge” on page 17.
electricity discharge” on page 17.
3
Remove the two screws that secure the “dummy” unit to the drive bay.
4
Slide the “dummy” unit back slightly to disengage the hooks on the drive
bay from the slots on the bracket, then pull the “dummy” unit out of
the chassis.
bay from the slots on the bracket, then pull the “dummy” unit out of
the chassis.
Important
The CD drive assembly should include the bracket and
small circuit board. If it does not, contact Client Care.
small circuit board. If it does not, contact Client Care.
“Dummy” unit
8507328.book Page 24 Thursday, February 15, 2001 11:28 AM