Gateway E-9722R User Manual
CHAPTER 6: Troubleshooting
72
Internet
You cannot connect to the Internet
•
Make sure that your account with your Internet Service Provider (ISP) is set up correctly.
Contact your ISP technical support for help.
Contact your ISP technical support for help.
Keyboard
Liquid has been spilled into the keyboard
•
If you spilled liquid in the keyboard, turn off your server and unplug the keyboard. Clean
the keyboard and turn it upside down to drain it. Let the keyboard dry before using it again.
If the keyboard does not work after it dries, you may need to replace it. This type of damage
is not covered by your server’s warranty.
the keyboard and turn it upside down to drain it. Let the keyboard dry before using it again.
If the keyboard does not work after it dries, you may need to replace it. This type of damage
is not covered by your server’s warranty.
LED information
See
for a description of this server’s LEDs and the information they
provide.
Memory
Memory errors were detected during server start up
•
Open your server and make sure that the memory modules are installed correctly. For
instructions, see
instructions, see
•
A memory module may be defective. If possible, try another memory module and see if
the error repeats.
the error repeats.
Monitor
Your server is running but there is no picture
•
Adjust the brightness and contrast controls to the center position.
•
Make sure that the monitor is plugged in and turned on. If the monitor is turned on, the
power LED should be lit.
power LED should be lit.
•
Check the port and cable for bent or damaged pins.
•
Connect your monitor to another computer, or connect a monitor that you know works to
your server.
your server.
The color is not uniform
Make sure that the monitor warms up for at least 30 minutes before making a final judgment
about color uniformity.
Make sure that:
Make sure that the monitor warms up for at least 30 minutes before making a final judgment
about color uniformity.
Make sure that:
•
The monitor is not positioned too close to another monitor, electric fan, or fluorescent light.
•
You demagnetize the screen using the monitor’s degauss feature. For more information on
degauss, see the monitor’s documentation.
degauss, see the monitor’s documentation.
A horizontal line or wire is visible across the CRT monitor screen
The monitor may use thin damper wires, located approximately 1/3 of the way from the upper
and lower screen edges, to stabilize the internal aperture grille. These wires are most obvious
when the monitor displays a white background. The aperture grille allows more light to pass
through the screen for brighter colors and greater luminescence. The damper wire is a critical
part of the overall monitor design and does not negatively affect the monitor’s function.
The monitor may use thin damper wires, located approximately 1/3 of the way from the upper
and lower screen edges, to stabilize the internal aperture grille. These wires are most obvious
when the monitor displays a white background. The aperture grille allows more light to pass
through the screen for brighter colors and greater luminescence. The damper wire is a critical
part of the overall monitor design and does not negatively affect the monitor’s function.