Gateway E-9722R User Manual
CHAPTER 4: Installing Components
50
Replacing the control panel
To replace the control panel adapter card:
1
Follow the instructions in
. Make sure
that you turn off the server, then unplug the power cord(s) and all other cables connected
to the server.
to the server.
2
Follow the instructions in
.
3
Disconnect all cables from the control panel.
4
Press down the two side locking tabs, then pull the control panel back and lift it out of
the chassis
the chassis
5
Holding the new control panel by the edges, align it with the locking tabs in the chassis,
then slide it toward the front of the chassis.
then slide it toward the front of the chassis.
6
Reconnect the cables to the control panel.
7
Follow the instructions in
Replacing the system board
To replace the system board:
1
Follow the instructions in
. Make sure
that you turn off the server, then unplug the power cord(s) and all other cables connected
to the server.
to the server.
2
Follow the instructions in
.
3
Remove the PCI riser assembly by following the instructions in
4
Remove the fan duct and system fan cage by following the instructions in
.
5
Remove the memory modules by following the instructions in
.
6
Remove the heatsinks and processors by following the instructions in
.
7
Disconnect all cables from the system board, noting their locations and orientation. (You
will reconnect the cables after you install the new board.)
will reconnect the cables after you install the new board.)
Caution
Your server must be operated with a control panel in place.