Gateway E-9722R User Manual
www.gateway.com
73
Bootblock recovery code checkpoints
The bootblock recovery code gets control when the BIOS determines that a BIOS recovery needs
to occur because the user has forced the update or the BIOS checksum is corrupt. The following
table provides the diagnostic LED codes for these checkpoints and describes the type of
checkpoints that may occur during the Bootblock recovery portion of the BIOS:
to occur because the user has forced the update or the BIOS checksum is corrupt. The following
table provides the diagnostic LED codes for these checkpoints and describes the type of
checkpoints that may occur during the Bootblock recovery portion of the BIOS:
D8
The Runtime module is uncompressed into memory. CPUID information is stored in
memory.
memory.
D9
Store the Uncompressed pointer for future use in PMM. Copying Main BIOS into
memory. Leaves all RAM below 1 MB Read-Write, including E000 and F000 shadow
areas, but closing SMRAM.
memory. Leaves all RAM below 1 MB Read-Write, including E000 and F000 shadow
areas, but closing SMRAM.
DA
Restore CPUID value back into register. Give control to BIOS POST
(ExecutePOSTKernel). See
(ExecutePOSTKernel). See
for more
information.
Check
point
Description
E0
Initialize the floppy controller in the super I/O. Some interrupt vectors are initialized.
DMA controller is initialized. 8259 interrupt controller is initialized. L1 cache is
enabled.
DMA controller is initialized. 8259 interrupt controller is initialized. L1 cache is
enabled.
E9
Set up floppy controller and data. Attempt to read from floppy.
EA
Enable ATAPI hardware. Attempt to read from ARMD and ATAPI CDROM.
EB
Disable ATAPI hardware. Jump back to checkpoint E9.
EF
Read error occurred on media. Jump back to checkpoint EB.
E9 or
EA
EA
Determine information about root directory of recovery media.
F0
Search for pre-defined recovery file name in root directory.
F1
Recovery file not found.
F2
Start reading FAT table and analyze FAT to find the clusters occupied by the recovery
file.
file.
F3
Start reading the recovery file cluster by cluster.
F5
Disable L1 cache.
FA
Check the validity of the recovery file configuration to the current configuration of
the flash part.
the flash part.
FB
Make flash write-enabled through chipset and OEM-specific method. Detect correct
flash part. Verify that the found flash part size equals the recovery file size.
flash part. Verify that the found flash part size equals the recovery file size.
F4
The recovery file size does not equal the found flash part size.
FC
Erase the flash part.
FD
Program the flash part.
FF
The flash has been updated successfully. Make flash write-disabled. Disable ATAPI
hardware. Restore CPUID value back into register. Give control to F000 ROM at
F000:FFF0h.
hardware. Restore CPUID value back into register. Give control to F000 ROM at
F000:FFF0h.
Check
point
Description