JVC 0105kth-mw-bj User Manual
Filename [XV38ASAG_07Editing.fm]
Masterpage:Left+
52
EN
Page 52
December 8, 2004 3:59 pm
SYSTEM CONNECTIONS (cont.)
Connecting To A Dolby
Digital Decoder or An
Amplifier With A Built-in
DTS (DVD deck)
These instructions enable you to connect your unit to a
Dolby Digital Decoder or an amplifier with built-in DTS.
Dolby Digital Decoder or an amplifier with built-in DTS.
Make connections.
Connect the optical cable between the unit and the
Dolby Digital Decoder or amplifier with a built-in DTS.
Dolby Digital Decoder or amplifier with a built-in DTS.
NOTES:
● For Dolby Digital sound, set “DIGITAL AUDIO OUTPUT” to
“DOLBY DIGITAL/PCM”. (
墌
pg. 57)
● For DTS sound, set “DIGITAL AUDIO OUTPUT” to “STREAM/
PCM”. (
墌
pg. 57)
CAUTIONS:
● This unit has a dynamic range of more than 80 dB with regards
to its Hi-Fi audio capability. It is recommended that you check
the maximum level if you are going to listen to the Hi-Fi audio
signals through a stereo amplifier. A sudden surge in the input
level to the speakers may damage them.
the maximum level if you are going to listen to the Hi-Fi audio
signals through a stereo amplifier. A sudden surge in the input
level to the speakers may damage them.
● Some speakers and televisions are specially shielded to
prevent television interference. If both are of the non-shielded
type, do not place the speakers adjacent to the TV set as this
can adversely affect the video playback picture.
type, do not place the speakers adjacent to the TV set as this
can adversely affect the video playback picture.
Note for connection:
Remove the connector cover from
the unit and remove the protection
cap from the cable.
Remove the connector cover from
the unit and remove the protection
cap from the cable.
Optical cable
(not provided)
(not provided)
Dolby Digital Decoder or
amplifier with built-in DTS
amplifier with built-in DTS
DIGITAL
AUDIO OUT
AUDIO OUT
To DIGITAL AUDIO
input
input
XV38ASAG_EN_BOOK.book Page 52 Wednesday, December 8, 2004 4:00 PM