JVC dr-m10s User Manual

Masterpage:Right-No-Heading

Filename [DR-M10SE_11Subsidiary.fm]

Page 93

February 12, 2004 5:31 pm

(The boldface settings in the table below indicate the settings at your purchase.)

8 DIGITAL AUDIO OUT

DOLBY DIGITAL/PCM
STREAM/PCM
PCM ONLY

Set to the appropriate mode according to the type of the device connected to 
DIGITAL OUT connector.

DOLBY DIGITAL/PCM

:

Select this when you connect the digital input connector of a Dolby 
Digital decoder or an amplifier with a built-in Dolby Digital 
decoder.

:

Select this when you connect the digital input connector of an 
amplifier with a built-in DTS, Dolby Digital, or MPEG multichannel 
decoder.

PCM ONLY

:

Select this when you connect the linear PCM digital input of other 
audio equipment (amplifier, MD or DAT deck, etc.).

8 ANALOG AUDIO OUT

STEREO
DOLBY SURROUND

Select the appropriate setting to accommodate the unit to the connected A/V 
equipment. This function takes effect when a DVD VIDEO disc is played back.

:

Select this when listening to conventional two-channel stereo audio 
with the unit’s AUDIO OUT connectors connected to a stereo 
amplifier/receiver or TV set, or in case you want to record the audio 
from a DVD VIDEO disc to a Mini Disc, etc.

DOLBY SURROUND

:

Select this when listening to multichannel surround audio with the 
unit’s AUDIO OUT connectors connected to an amplifier/receiver 
with a built-in surround decoder or a surround decoder.

8 D. RANGE CONTROL

NORMAL
WIDE RANGE
TV MODE

The dynamic range (the difference between the loudest sound and the quietest 
one) can be compressed during playback of a programme encoded in Dolby 
Digital format.
This function takes effect when a DVD VIDEO disc recorded in Dolby Digital 
format is played back at low or middle volume.

:

Normally select this setting to activate this function.

WIDE RANGE

:

Select this to deactivate this function when you enjoy wide dynamic 
range programme.

TV MODE

:

Select this when you hear the sound through the TV’s speaker(s).

● This function takes no effect on programmes other than that recorded in Dolby Digital 

format.

● This function dose not work when Simulated Surround Effect is activated. (

● The effect of “NORMAL” and “WIDE RANGE” may not be different depending on discs.

8 OUTPUT LEVEL

STANDARD
LOW

You can lower the output level of analog audio to accommodate the unit to the 
connected A/V equipment.

:

Normally select this setting.

LOW

:

The output level of analog audio is lowered.

DR-M10SE_01.book  Page 93  Thursday, February 12, 2004  9:08 PM