JVC 0905tnh-fn-fn User Manual

33

EN

If programming has been made at the end of the 
programming (PROG. 1) currently being recorded:
• The timer programming set first (PROG. 2) has 

priority. PROG. 3 will not be recorded.

If the recording time is partially overlapped:
• The timer programming with the earlier start time 

(PROG. 2) has priority. PROG. 1 will start after 
PROG. 2 recording is complete.

If the recording time entirely overlaps:
• The shorter timer programming (PROG. 1) is not 

recorded.

Note for DVD recording
• If the recording time of two programmes overlap, or 

the End time of a programme and the Start time of 
another is same, the first 30 seconds (at the most) 
of the subsequent programme are cut off.

If the End time of the programme currently being 
recorded and the Start time of the subsequent 
programme are same:
• If PROG. 1 is a DVD recorded programme, the 

beginning of PROG. 2 may be cut off.

* If the cut off time exceeds 1 minute, the error 

number “E40” will appear in the timer programming 
list.

Connect the external equipment using either the input 
jacks, AV1, AV2 (Rear) or AV3 (Front). However, for 
AV3 jacks, you have to select S-VIDEO input or 
VIDEO input jacks depending on the connected 
devices.
Use commercially available Scart, S-Video or Video 
cable and an Audio cable for this connection.

U / D], then press 

If it has already appeared, proceed to step 3.

U / D], then press [ENTER].

U / D], then press 

• If you want to use VIDEO input jack (Composite), 

select “Video In.”

• If you want to use S-VIDEO input jack, select

“S-Video In.”

PROG. 2 
recording 
will start 
after 
PROG. 1 
recording is 
completed.

Additional 30 seconds (at the most) are cut off.

Additional 30 seconds (at the most) are cut off.

The first 30 seconds 

(at the most) are cut off.*

E9770ED_EN.book  Page 33  Wednesday, August 3, 2005  6:35 PM