JVC hr-dvs2 User Manual
4
EN
Basic
Connection
CHECK CONTENTS
1
Make sure the package contains all of the accessories
listed in "Specifications" (
墌
pg. 86).
SITUATE RECORDER
2
Place the recorder on a stable, horizontal surface.
CONNECT RECORDER TO
TV
3
a– Disconnect the TV aerial cable from the TV.
b– Connect the TV aerial cable to the ANTENNA IN
b– Connect the TV aerial cable to the ANTENNA IN
jack on the rear panel of the recorder.
c– Connect the provided RF cable between the
ANTENNA OUT jack on the rear panel of the
recorder and the TV’s aerial terminal.
recorder and the TV’s aerial terminal.
d– Connect the provided SCART cable between the
AV1 (L-1) IN/OUT socket on the rear panel of the
recorder and the TV’s 21-pin SCART connector.
recorder and the TV’s 21-pin SCART connector.
● The AV1 (L-1) IN/OUT connector accepts and
delivers either a composite signal (regular video
signal) or a Y/C signal (a signal in which the lumi-
nance and chrominance signals are separated). If
your TV's 21-pin AV input connector (SCART) is
compatible with the Y/C signal, set "L-1 OUTPUT" to
"S-VIDEO" after the connection and the initial settings
are completed (
signal) or a Y/C signal (a signal in which the lumi-
nance and chrominance signals are separated). If
your TV's 21-pin AV input connector (SCART) is
compatible with the Y/C signal, set "L-1 OUTPUT" to
"S-VIDEO" after the connection and the initial settings
are completed (
墌
pg. 58). You can obtain high-
quality S-VHS pictures. (For connection, be sure to
use a 21-pin SCART cable that is compatible with the
Y/C signal.)
use a 21-pin SCART cable that is compatible with the
Y/C signal.)
● Set your TV to the VIDEO (or AV), Y/C, or RGB mode
according to the type of your TV's SCART connector.
● For switching the TV's mode, refer to the instruction
manual of your television.
● To obtain high-quality S-VHS pictures, you can also
use the S-VIDEO Connection described on page 5.
CONNECT RECORDER TO
MAINS
4
Connect the provided mains power cord between the
mains power inlet on the rear panel of the recorder and
a mains outlet.
a mains outlet.
It's essential that your video recorder be properly connected.
Follow these steps carefully. THESE STEPS MUST BE COMPLETED
BEFORE ANY VIDEO OPERATION CAN BE PERFORMED.
Follow these steps carefully. THESE STEPS MUST BE COMPLETED
BEFORE ANY VIDEO OPERATION CAN BE PERFORMED.
INSTALLING YOUR NEW RECORDER
21-pin SCART Cable
(provided)
(provided)
21-pin SCART
connector
connector
Back of TV
Aerial terminal
Rear view
Mains outlet
AV1 (L-1) IN/OUT
RF Cable
(provided)
(provided)
TV Aerial
Cable
Cable
After you plug the mains power cord into a mains outlet, the
Country Set display appears on the TV screen and/or on the
recorder's front display panel when the
Country Set display appears on the TV screen and/or on the
recorder's front display panel when the
button on the
recorder/remote control is pressed for the first time to power
on the recorder; go to page 6 to perform Auto Set Up.
on the recorder; go to page 6 to perform Auto Set Up.
ATTENTION:
Your TV must have a 21-pin AV input connector (SCART) for
the connection to the recorder.
the connection to the recorder.