JVC hv10

Trouble? 

Printing

Editing

Others

List of Messages

The printer is not operating 
even though the camcorder 
and printer are correctly 
connected.

Disconnect the USB cable and turn off the camcorder and the 
printer. After a short while, turn them on again, set the 
camcorder to 

 mode and restore the connection.

–

Cannot record with this 
camcorder video input from an 
external video device 
connected to the HDV/TV 
terminal using a DV cable.

Set [AV

DV] to [OFF].

33

Wrong signal standard. Dubbing may work using the AV IN/OUT 
terminal.
Refer also to the instruction manual of the connected device.

–

A rattling can be heard from the 
camcorder.

The internal lens fixture can move when the camcorder is turned 
off. This is not a malfunction.

–

SET THE TIME ZONE, 
DATE AND TIME

You have not set the time zone, date and time. This message 
appears each time you turn the power on until you set the time 
zone, date and time.

24

CHANGE THE BATTERY 
PACK

Battery pack is exhausted. Replace or charge the battery pack.

18

THE TAPE IS SET FOR 
ERASURE PREVENTION

Cassette is protected. Replace the cassette or change the position 
of the protect switch.

80

REMOVE THE CASSETTE

Camcorder stopped operating to protect the tape. Remove the 
cassette and reinsert it.

19

CHECK THE HDV/DV 
INPUT
(Appears only if a DV cable is 
connected)

The DV cable is not correctly connected to the HDV/DV terminal, or 
the connected digital device is turned off.

57

The video input signal is in a different television system (PAL or 
SECAM).

–

CONDENSATION HAS 
BEEN DETECTED

Condensation has been detected in the camcorder.

82

CONDENSATION HAS 
BEEN DETECTED 
REMOVE THE CASSETTE

Condensation has been detected in the camcorder. Remove the 
cassette. 

82

TAPE END

Tape reached the end. Rewind the tape or replace the cassette.

–