JVC LST0723-001A User Manual

©  2008 Victor Company of Japan, Limited

LST0723-001A

The ceiling mount bracket comes attached to the camera unit. Before 
installing, unfasten the ceiling mount bracket from the camera unit.

A Check to ensure that the camera fixing lock knobs (x2) is not turned on.

● If it is locked, slide the camera fixing lock knobs to unlock in the 

direction as shown below.

B Push in the camera fixing lock knobs (x2) from both left and right sides 

in the direction as illustrated in the diagram.

● Unfasten the ceiling mount bracket on a table to prevent it from falling off.

：                                                                                         

● If it is difficult to push in the camera fixing lock knob, push in while 

pressing the edge of camera (figure A) against the table where the 

process is being carried out.

C Lift the camera unit upward to remove the ceiling mount bracket, and 

pull down in the direction as indicated.

䡵 Precautions during transportation

When mounting ceiling mount bracket to the camera unit during 
transportation, let out the tip of fall prevention wire so that it is not caught.
If the fall prevention wire is caught in the gap of ceiling mount bracket, the 
ceiling mount bracket might not be able to detached from the camera unit.

C

B

B

A

A

Camera fixing lock

knob (x2)

Ceiling  mount  bracket

Camera unit

Let out the tip of fall prevention 
wire

686sheet.fm  Page 1  Wednesday, March 19, 2008  9:57 PM