JVC CA-UXNB7DAB User Manual

Page of 24
2
Notes on the power cord
•  
When you are away on travel or otherwise for an 
extended period of time, remove the plug from the 
wall outlet. A small amount of power (2.5 W) is always 
consumed while the power cord is connected to the 
wall outlet.
•  When unplugging the System from the wall outlet, 
always pull the plug, not the power cord.
•  Do not handle the power cord with wet hands.
•  Disconnect the power cord before cleaning the System 
or moving the System.
•  Do not alter, twist or pull the power cord, or put 
anything heavy on it, which may cause fi re, electric 
shock, or other accidents.
•  If the cord is damaged, consult a dealer and have the 
power cord replaced with a new one.
Avoid moisture, water, dust, and high temperatures
•  
Do not place the System in moist or dusty places.
•  If water gets inside the System, turn off  the power and 
remove the plug from the wall outlet, then consult your 
dealer. Using the System in this state may cause a fi re or 
electrical shock.
•  Do not expose the System to direct sunlight or place it 
near a heating device.
Precautions
Notes on installation
•  
Select a place which is level, dry and neither too hot nor 
too cold between 5˚C and 35˚C.
•  Do not install the System in a place subject to vibrations.
•  Do not put heavy objects on the System.
To prevent malfunction or damage of the System
•  
Do not insert any metallic objects, such as wires, 
hairpins, coins, etc. into the System.
•  Do not block the vents.
To clean the cabinet
•  
Use a soft cloth. Follow the relevant instructions on the 
use of chemically-coated cloths.
•  Do not use benzene, thinner or other organic solvents 
and disinfectants. These may cause deformation or 
discoloring.
There are no user-serviceable parts inside. If 
anything goes wrong, unplug the power cord 
and consult your dealer.
 Supplied Accessories
After unpacking, check to be sure that you have all the following items. The number in parentheses indicates the 
quantity of each piece supplied.
Getting Started
 Prepare the Remote Control
When you use the remote control for the fi rst time, pull 
out the insulation sheet.
Insulation sheet
Replacing the Battery in the Remote Control
Insert the battery into the remote control by matching 
the polarity (+ and –) correctly.
Lithium coin battery
(product number: CR2025)
NOTES
•  Store the battery in a place where children cannot 
reach. If a child accidentally swallows the battery, 
consult a doctor immediately.
•  Do not recharge, short, disassemble or heat the battery 
or dispose of it in a fi re. Doing any of these things may 
cause the battery to give off  heat, crack, or start a fi re.
•  Do not leave the battery with other metallic materials. 
Doing this may cause the battery to give off  heat, crack, 
or start a fi re.
•  When throwing away or saving the battery, wrap it in 
tape and insulate; otherwise, the battery may start to 
give off  heat, crack, or start a fi re.
•  Do not poke the battery with tweezers or similar tools. 
Doing this may cause the battery to give off  heat, crack, 
or start a fi re.
•  Dispose of battery in the proper manner, according to 
federal, state, and local regulations.
CAUTION:
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
•  Remote control (x 1)
•  Lithium coin battery CR2025 (x 1) (The battery has 
been installed when shipped from the factory.)
•  AM loop antenna (x 1)
•  FM antenna (x 1)
•  DAB antenna (x 1)
If anything is missing, consult your dealer immediately.
EN_01_20_UX-NB7DAB[B]ff.indd   2
EN_01_20_UX-NB7DAB[B]ff.indd   2
06.7.6   11:27:04 AM
06.7.6   11:27:04 AM