packardbell easynote w7 dragon sn Service Manual
1
Overview
This document contains step-by-step disassembly instructions for the EasyNote W7
(Dragon SN) chassis. The instructions are illustrated where necessary with images of
the part that is being removed or disassembled.
(Dragon SN) chassis. The instructions are illustrated where necessary with images of
the part that is being removed or disassembled.
Packard Bell reserves the right to make changes to the chassis without notice.
Disassembly Instructions
When disassembling the system unit, follow these general rules:
n
Turn off the power.
n
Disconnect the AC adapter.
n
Remove the battery.
n
Do not disassemble the system into parts that are smaller than those specified
in the instructions.
in the instructions.
n
Label all removed connectors; note where the connector goes and in what
position it was installed.
position it was installed.
Reassembly Instructions
Reassembly is the reverse of the disassembly process. Use care to ensure that all
cables and screws are returned to their proper positions. Check that no tools or any
loose parts have been left inside the chassis. Check that everything is properly installed
and tightened.
cables and screws are returned to their proper positions. Check that no tools or any
loose parts have been left inside the chassis. Check that everything is properly installed
and tightened.
Required Tools
All disassembly procedures can be performed using the following tools:
n
Philips (#2 bit) screwdriver
n
Hex bolt screwdriver