Yamaha 007POTO-G0 User Manual

LS9-16/32  Owner’s Manual

The 

ø

 button will change from black to red, and the 

phase of the corresponding channel will be reversed.

For example if INPUT channels 1–8 are shown in the 
popup window, pressing the INPUT channel 9 [SEL] 
key will change the popup window to INPUT channels 
9–16.

× symbol in the upper right of the win-

Here we will explain how to send the signal of an input channel to the STEREO bus or MONO 
bus.
The STEREO bus / MONO bus are used to output signals to the main speakers. Signals can be 
sent to the STEREO bus or MONO bus in either ST/MONO mode or LCR mode, and you can 
choose either of these two modes for each channel. These two modes differ as follows.

■ ST/MONO mode

 • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • 

In this mode, signals are sent independently from the input channel to the STEREO bus and to the MONO bus.

• The signals sent from the same input channel to the STEREO bus and to the MONO bus can be switched on/

off independently.

• The panning of the signal sent from an INPUT channel to the STEREO bus L/R can be operated by the 

SELECTED CHANNEL section [PAN] encoder, or by the TO ST PAN knob in the screen. (The signal sent to 
the MONO bus is not affected by this encoder or knob.)

• The volume balance of the signal sent from a ST IN channel to the STEREO bus left and right can be operated 

by the SELECTED CHANNEL section [PAN] encoder, or by the TO ST BALANCE knob in the screen. (The 
signal sent to the MONO bus is not affected by this knob.)

■ LCR mode

 • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • 

In this mode, the signal from the input channel is sent to three buses at once; STEREO (L/R) and MONO (C).

• The signals sent from the same input channel to the STEREO bus and to the MONO bus can be switched on/

off together.

• The CSR (Center Side Ratio) knob in the screen adjusts the proportion of the signal level sent from the input 

channel to the STEREO (L/R) bus and the level sent to the MONO (C) bus.

• The level of the signal sent from the input channel to the STEREO (L/R) bus and the MONO (C) bus will 

change according to the settings of the SELECTED CHANNEL section [PAN] encoder or the TO ST PAN 
knob / TO ST BALANCE knob in the screen.

Sending the signal from an input channel to the STEREO/MONO bus