Yamaha 007POTO-G0 User Manual

6

Output channel oper

ations

LS9-16/32  Owner’s Manual

This section explains how to send the signal from a MIX channel or STEREO/MONO channel to 
MATRIX buses 1–8. You can do this in any of the following three ways.

■ Using the SELECTED CHANNEL section

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • 

In this method, you use the SELECTED CHANNEL section [SELECTED SEND] encoder to adjust the level of 
the signal sent to the MATRIX bus.

■ Using a popup window

 • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • 

In this method, you use the MATRIX SEND popup window to adjust the send levels from eight channels to a 
MATRIX bus.
This method lets you control the send level, on/off setting, and send point for the signals sent from a set of eight 
channels to a specific MATRIX bus.

■ Using the top panel faders

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • 

In this method, you switch the LS9 to SENDS ON FADER mode and use the top panel faders to adjust the send 
levels to the MATRIX bus. This method lets you simultaneously control the send levels and on/off switching for 
the signals sent from MIX, STEREO (L/R), and MONO channels to a specific MATRIX bus.

In this method, you use the SELECTED CHANNEL sec-
tion [SELECTED SEND] encoder to adjust the level of 
the signal sent to the MATRIX bus.
You can either control the signals sent from a desired 
MIX, STEREO (L/R), or MONO channel to all MATRIX 
buses, or control the signals sent from all MIX channels to 
a specific MATRIX bus.

■ Controlling the signals sent from a MIX, 

The SELECTED CH VIEW screen will appear in the 
display.

1

If a MIX, STEREO (L/R), or MONO channel is 
selected, this area of the SELECTED CH VIEW 
screen will show the TO MATRIX field, allowing you 
to switch the on/off status and adjust the send level of 
the signals sent to the MATRIX buses.

B

These adjust the send level of the signals sent from the 
MIX, STEREO (L/R), or MONO channel to the 
MATRIX buses. These knobs are the same color as the 
corresponding keys of the MIX/MATRIX SEND sec-
tion.
To adjust the send level in this field, move the cursor to 
the knob and use the dial or the [DEC]/[INC] keys. To 
switch the on/off status of a signal sent to a MATRIX 
bus, move the cursor to the corresponding knob and 
press the [ENTER] key.

Sending signals from MIX channels and STEREO/MONO channels 

to MATRIX buses

Using the SELECTED CHANNEL sec-
tion

1

2