Yamaha 9000 pro User Manual

Creating Plug-in Custom Voices

Creating Plug-in Custom Voices

Native System Parameter Editing

The word “native” here describes the parameters that are exclusive to each of the Plug-
in Boards.  Because of this, the editing screens displayed on the 9000Pro will differ 
depending on the particular Plug-in Board being used.  For example, when editing 
Plug-in voices of the PLG150-VL, parameter names such as “WX Lip” and “Brth 
Curv” (Breath Curve) which are unique to the VL tone generation system are dis-
played, as shown below on the right.

The illustration below applies to step #7 of the Basic Procedure on page 101.

Select the desired Board. 

When the same (or same type) 
of Plug-in Boards (e.g., the 
PLG100-DX and the PLG150-
DX) have been installed in the 
two slots, only SLOT 1 is avail-
able.

This lets you change the volume out-
put from the Plug-in Board and adjust 
the relative balance among the 
9000Pro preset voices and the Plug-
in voices. 
Please note the following points.
• The volume balance of the song 

using the Plug-in voices is changed 
by adjusting this value.

• When the same (or same type) of 

Plug-in Boards have been installed 
in the two slots, only the value set 
for SLOT 1 is available. 

NEXT

BACK

PAGE CONTROL

You can store the settings in this display 
to Flash ROM by using this button. 

103