Yamaha CLP-F01 User Manual

CLP-F01

   Selecting & Playing Voices

Press a voice button.

Press the corresponding voice button while holding the 

 button. (The 

indicator of the Left Voice button will light while the 

 button is pressed.)

To turn the variation on or off for the split voice, hold the 

 button and 

press the

 button or the currently-selected voice button.

Press the 

 button again so that its indicator goes out.

You can turn the variation on or 
off for Split mode voices. Nor-
mally, the voice indicator of the 
right voice lights in Split mode. 
The [VARIATION] can be used 
to turn the variation for the right 
voice on or off as required. 
While the [SPLIT] button is 
held, however, the voice indica-
tor of the left voice lights. In this 
state the [VARIATION] button 
turns the variation for the left 
voice on or off.

The reverb type assigned to the 
right voice will take priority over 
the other. (If the reverb is set to 
OFF, the left voice’s reverb type 
will be in effect.) Reverb depth 
setting via the panel controls 
(i.e. pressing the [–/NO] or [+/
YES] buttons while holding the 
[REVERB] button — see 
page 24) will be applied to the 
right voice only.

Depending on the conditions, 
one effect type will take priority 
over the other. The depth will be 
decided according to the depth 
default value of the voice combi-
nation. However, using function 
F4 (page 45) you can change 
the depth value for each voice 
as you like. Effect depth setting 
via the panel controls (i.e. 
pressing the [–/NO] or [+/YES] 
buttons while holding the 
[EFFECT] button — see 
page 25) will be applied to the 
right voice only.