Yamaha ga24-12 User Manual
12
Master Section
GA32/12, GA24/12—Owner’s Manual
C-R MONI (Control room monitor) section
PHONES (headphones) section
PHONES (headphones) section
This section enables you to control signals monitored via the C-R MONITOR OUT jacks (see
page 18, rear panel
page 18, rear panel
M
) and the PHONES jack on the front panel (C-R MONI section/
PHONES section
6
).
A
Monitor source select switch
This switch enables you to select the type of signal to monitor via the C-R MONITOR OUT
jacks and the PHONES jack.
jacks and the PHONES jack.
■ When the switch is set to PFL/AFL (
)
You will monitor PFL signals (signals routed from input channels/AUX returns to the PFL bus)
or AFL signals (signals routed from MIX buses 1–10/ST buses/MATRIX 1–2 to the AFL bus).
or AFL signals (signals routed from MIX buses 1–10/ST buses/MATRIX 1–2 to the AFL bus).
If any one of the PFL switches for the input channels/AUX returns is turned on, the PFL
indicator
indicator
2
will light up. In this case, the PFL bus signals (not the AFL bus signals) are routed
to the C-R MONITOR OUT jacks and PHONES jack. If all the PFL switches are turned off, the
AFL bus signals are sent to the C-R MONITOR OUT jacks and PHONES jack.
AFL bus signals are sent to the C-R MONITOR OUT jacks and PHONES jack.
■ When the switch is set to TAPE IN (
)
You can monitor the signals input from the TAPE IN jacks (see page 18, rear panel
N
).
B
PFL (Pre-fader Listen) indicator
This indicator lights up when any one of the PFL switches for the input channels/AUX returns
is turned on, indicating that the PFL bus signal is currently being monitored.
is turned on, indicating that the PFL bus signal is currently being monitored.
C
LEVEL control
This control enables you to adjust the level of signals output from the C-R MONITOR OUT
jacks. This setting does not affect the signal level at the PHONES jack.
jacks. This setting does not affect the signal level at the PHONES jack.
D
ON switch
This switch turns on and off the monitoring signals output from the C-R MONITOR OUT
jacks. It does not affect signals at the PHONES jack.
jacks. It does not affect signals at the PHONES jack.
E
LEVEL (Headphones level) control
This control enables you to adjust the level of signals output from the PHONES jack. This
setting does not affect the signal level at the C-R MONITOR OUT jacks.
setting does not affect the signal level at the C-R MONITOR OUT jacks.
F
PHONES (Headphones) jack
Connect monitoring stereo headphones here. See
the figure on the right for wiring.
the figure on the right for wiring.
Note: If you turn on any one of the PFL switches for the input channels/AUX returns while
monitoring the AFL bus signal, the switching circuit will switch the signal to the PFL bus
signal.
monitoring the AFL bus signal, the switching circuit will switch the signal to the PFL bus
signal.
C-R MONI
PHONES
ON
PFL
PFL/AFL
TAPE IN
TAPE IN
LEVEL
10
0
LEVEL
10
0
2
3
5
6
1
4
1/4" TRS phone plug
Tip (left)
Ring (right)
Sleeve (ground)