Yamaha HTR-5450RDS User Manual
19
English
B
ASIC OPERA
TION
AD
V
V
ANCED OPERA
TION
APPENDIX
INTR
ODUCTION
PREP
ARA
TION
ADJUSTING THE SPEAKER BALANCE
Using the Test Tone
The adjustment of each speaker sound output level should
be performed at your listening position with the remote
control.
be performed at your listening position with the remote
control.
1
Press AMP(TUNER) on the
component selector.
component selector.
2
Press TEST.
“TEST LEFT” appears on the display.
“TEST LEFT” appears on the display.
3
Turn up the volume.
You will hear a test tone (like pink noise) from each
speaker for about two seconds in following order: left
main speaker, center speaker, right main speaker, right
rear speaker and left rear speaker. The display changes
as shown below.
You will hear a test tone (like pink noise) from each
speaker for about two seconds in following order: left
main speaker, center speaker, right main speaker, right
rear speaker and left rear speaker. The display changes
as shown below.
Notes
• If the test tone cannot be heard, turn down the volume, set the unit
in the standby mode and check the speaker connections.
• If the test tone cannot be heard from the center speaker, check the
setting of “CENTER SP” in the SET MENU.
This procedure lets you adjust the sound output level
balance between the main, center and rear speakers by using
the built-in test tone generator. When this adjustment is
performed, the sound output level heard at the listening
position will be the same from each speaker. This is
important for the best performance of the digital sound field
processor, the Dolby Pro Logic decoder, Dolby Digital
decoder and DTS decoder.
balance between the main, center and rear speakers by using
the built-in test tone generator. When this adjustment is
performed, the sound output level heard at the listening
position will be the same from each speaker. This is
important for the best performance of the digital sound field
processor, the Dolby Pro Logic decoder, Dolby Digital
decoder and DTS decoder.
Note
• Since this unit cannot enter the test mode while headphones are
connected to this unit, be sure to unplug the headphones from the
PHONES jack when using the test tone.
PHONES jack when using the test tone.
Before You Start Adjusting
1
Set the volume at the
minimum level.
minimum level.
2
Turn the power on.
3
Press SPEAKERS A or B
to select the main
speakers to be used.
If you use two main speaker
systems, press both A and B.
to select the main
speakers to be used.
If you use two main speaker
systems, press both A and B.
4
Set BASS, TREBLE and BALANCE to the
center position.
center position.
SILENT
VIDEO AUX
PHONES
S VIDEO
VIDEO
L AUDIO R
OPTICAL
6CH INPUT
INPUT MODE
INPUT
VOLUME
RDS MODE/FREQ
EON
PTY SEEK
MODE
START
TUNING
MODE
PRESET
/TUNING
FM/AM
MEMORY
EDIT
BASS
BALANCE
SPEAKERS
PROGRAM
PRESET/TUNING
EFFECT
A/B/C/D/E
A
B
OFF
ON
D I G I T A L
–
+
L
R
TREBLE
–
+
MAN'L/AUTO FM AUTO/MAN'L MONO
SURROUND
D I G I T A L
STANDBY
/ON
1
2
4
3
VOLUME
STANDBY
/ON
SPEAKERS
A
B
OFF
ON
BASS
BALANCE
–
+
L
R
TREBLE
–
+
1
2,6
5
3
TEST
LEFT
LEFT
TEST
RIGHT
TEST L SUR.
TEST R SUR.
TEST CENTER
0103V520RDS10-20_EN
1/31/1, 4:21 PM
19