Yamaha MCX-2000 User Manual

Page of 132
3
MCX-2000 Setup Guide
(DECLARATION OF CONFORMITY PROCEDURE)
Responsible Party:
Address:
Telephone:
Fax:
Type of Equipment:
Model Name:
Yamaha Electronics Corporation, U.S.A.
6660 Orangethorpe Avenue
Buena Park, CA 90620
714-522-9105
714-670-0108
Digital Audio Server
MCX-2000
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following conditions:
1) this device may not cause harmful interference, and
2) this device must accept any interference received including interference that may cause undesired operation.
See the “TROUBLESHOOTING” section at the end of this manual if interference to radio reception is suspected.
COMPLIANCE INFORMATION STATEMENT
FCC INFORMATION (for US customers only)
1 IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!
This product, when installed as indicated in the instructions 
contained in this manual, meets FCC requirements. Modifications 
not expressly approved by Yamaha may void your authority, 
granted by the FCC, to use the product.
2 IMPORTANT: When connecting this product to accessories and/
or another product use only high quality shielded cables. Cable/s 
supplied with this product MUST be used. Follow all installation 
instructions. Failure to follow instructions could void your FCC 
authorization to use this product in the USA.
3 NOTE: This product has been tested and found to comply with 
the requirements listed in FCC Regulations, Part 15 for Class “B” 
digital devices. Compliance with these requirements provides a 
reasonable level of assurance that your use of this product in a 
residential environment will not result in harmful interference 
with other electronic devices.
This equipment generates/uses radio frequencies and, if not 
installed and used according to the instructions found in the users 
manual, may cause interference harmful to the operation of other 
electronic devices.
Compliance with FCC regulations does not guarantee that 
interference will not occur in all installations. If this product is 
found to be the source of interference, which can be determined by 
turning the unit “OFF” and “ON”, please try to eliminate the 
problem by using one of the following measures:
Relocate either this product or the device that is being affected by 
the interference.
Utilize power outlets that are on different branch (circuit breaker 
or fuse) circuits or install AC line filter/s.
In the case of radio or TV interference, relocate/reorient the 
antenna. If the antenna lead-in is 300 ohm ribbon lead, change the 
lead-in to coaxial type cable.
If these corrective measures do not produce satisfactory results, 
please contact the local retailer authorized to distribute this type of 
product. If you can not locate the appropriate retailer, please 
contact Yamaha Electronics Corporation, U.S.A. 6660 
Orangethorpe Avenue, Buena Park, CA 90620.
The above statements apply ONLY to those products distributed 
by Yamaha Corporation of America or its subsidiaries.