Yamaha R-S300BL User Manual

Extreme caution should be exercised when you play back CDs encoded in DTS.
If you play back a CD encoded in DTS on a CD player that does not support DTS, only noise will be heard, and this noise 
may damage your speakers. Check whether your CD player supports CDs encoded in DTS. Also, check the sound output 
level of your CD player before you play back a CD encoded in DTS.

Press A (power) on the front panel inward to 
turn on this unit.

Press SPEAKERS A and/or SPEAKERS B on 
the front panel or on the remote control to 
select speakers A and/or speakers B.
When speaker set A or speaker set B are turned on, 
SP A or SP B is displayed on the front panel display 
accordingly (see page 6).

• When one set of speakers is connected using bi-wire 

connections, or when using two sets of speakers simultaneously 
(A and B), make sure SP A and SP B are displayed on the front 
panel display.

• When listening with headphones, turn off the speakers.

y

You can adjust the tonal quality by using the BASS, TREBLE, 
BALANCE and LOUDNESS controls, or the PURE DIRECT 
switch on the front panel (see page 15).

When finished listening, press A (power) on 
the front panel outward to turn off this unit.

y

If A (power) on the remote control is pressed while the A (power) 
button on the front panel is in the on position, this unit enters 
standby mode. Press A (power) again to turn this unit on.

A (power)

A (power)