Yamaha RX-V1900BL User Manual

You can program remote control codes from other remote 
controls. Use the learning feature if you want to program 
functions not included in the basic operations covered by 
the remote control codes, or an appropriate remote control 
code is not available. You can program the function of 
other remote control to the buttons in the highlighted areas 
in the following illustration. The buttons can be 
programmed independently for each control area.

• The remote control transmits infrared rays. If the other remote 

control also uses infrared rays, this remote control can learn 
most of its functions. However, you may not be able to program 
some special signals or extremely long transmissions.

• You cannot program the desired remote control code even if you 

select the buttons in the highlighted area in the above 
illustration depending on the selected control area and the 
assigned library.

Set the operation mode selector to 
E

SOURCE and then press an input selector 

button (3) to select the desired control area.
If you want to program the remote control code for 
“TV”, set the operation mode selector to ETV.

Make sure that the operation mode selector is set to 
ESOURCE or ETV. When you set the operation mode 
selector to EAMP and program a remote control codes 
from other remote controls, the programmed key cannot 
operate the amplifier function of this unit.

Press F

SETUP using a ballpoint pen or 

similar object.
“SETUP” appears in the display window (4).

Press 8k / n repeatedly to select “LEARN” 
and then press 8

ENTER.

Place this remote control about 5 to 10 cm (2 
to 4 in) apart from the other remote control 
on a flat surface so that their infrared 
transmitters are aimed at each other and 
then press 8

ENTER.

“L–KEY” appears in the display window (4).

Press the button for which you want to 
program the new function.
“START” appears in the display window (4).

Press and hold the button you want to 
program on the other remote control until 
“OK” appears in the display window (4).
“NG” appears in the display window (4) if learning 
was unsuccessful. In this case, start over from step 4.

y

When you want to program another function, repeat steps 
4 througn 6.

OK