Yamaha RX-497 User Manual

Plug the power supply cord into the AC wall outlet after 
all other connections are complete.

■ AC OUTLET(S) (SWITCHED)

Australia model  ..................................................... 1 outlet
Other models  ....................................................... 2 outlets
Use these outlets to connect the power supply cords from 
your other components to this unit. The outlets supply 
power to any connected components whenever the power 
of this unit is turned on. For information on the maximum 
power (total power consumption of components), see 
“SPECIFICATIONS” on page 45.

When all connections are complete, turn on the power of 
this unit.

Press MASTER ON/OFF on the front panel 
inward to the ON position to turn on the 
power of this unit.
Main Zone of this unit turns on.

• You can set Main Zone of this unit to the standby mode 

by pressing MAIN ZONE ON/OFF on the front panel 
or STANDBY on the remote control.
Press MAIN ZONE ON/OFF on the front panel or 
POWER on the remote control to turn Main Zone on 
again.

• Press MASTER ON/OFF on the front panel again to 

release it outward to the OFF position\ to turn off this 
unit.

y

While MASTER ON/OFF on the front panel is pressed inward to 
the ON position, you can turn on Zone 2 or set it to the standby 
mode independently (see page 38).

Ω

Ω

Ω

Ω

l TUNING/CH h

∞